ASSEMBLY
-10-
Beginning
Although the main components of the SHOP
FOX®W1675 are assembled at the factory,
some assembly is required. The following series
of instructions are the recommended sequence
for final assembly.
All tools required for assembly have been
included with the planer except standard-head
and Phillips®-head screwdrivers.
Keep your machine
unplugged during any
assembly, adjustments, or
maintenance procedures.
Ignoring this warning may
result in serious personal
injury!
Cleaning Machine
The Model W1675 table and other unpainted
parts are coated with a waxy grease for
corrosion protection. For the best machine
performance, clean all moving parts and
coated surfaces. Remove this grease with a
solvent cleaner or a citrus-based degreaser. Do
not use chlorine-based solvents—if you splash
these solvents onto a painted surface, you will
ruin painted and plastic finishes.
Before cleaning the machine, read and
understand the following Warnings and Caution:
Never use flammables
such as gas or other
petroleum-based solvents
to clean your machine.
These products have low
flash points and present
the risk of explosion and
severe personal injury!
Never smoke while using
cleaning solvents. Smoking
may cause explosion or
risk of fire when exposed
to these products!
Most solvents used to
clean machinery are
toxic when inhaled or
ingested. When using
these products, work in
a well ventilated area
and keep away from any
potential ignition
sources (pilot lights).
Always dispose of any
waste rags in a sealed
container to make sure
they do not cause fire or
environmental hazards.