Woodstock W1821 owner manual Illustrated example of a fence

SETUP

	Model W1821 (For Machines Mfg. Since 3/10)
5. If you have long fence rails that will extend beyond	Router Table T-Slot
the T-slots of the router table, you will have to
modify the top of the rails. This entails making a
cut-out that matches or exceeds the dimensions of
the router table T-slot, as shown in the illustration in	Fence Rail
Figure 7.	Cut-Out
Also, drill mounting holes through the rails that	Figure 7. Illustrated example of a fence
match the holes in the side of the router table.
	modification.

6.With the help of another person to hold the table

and leg assembly, align the mounting holes in both tables and secure them together with the (3) M8-1.25 x 30mm cap screws, (3) 8mm lock washers, and (3) 8mm flat washers, as shown in Figure 8.

— If you have fence rails that extend beyond the saw table and across the router table, use the

mounting holes you drilled in Step 5 to fasten the

rails to the router table. x 3

Figure 8. Router table attached to the

table saw.

7.Place the straightedge across the saw table and router table to make sure that the combined table surface is flat.

—If the combined table surface is flat, continue with Step 8.

—If the outside edge of the router table tilts down, place strips of masking tape along the bottom edge of the saw table to shim the router table up and even with the saw table from side to side (see

Figure 9).

—If the outside edge of the router table tilts up, place strips of masking tape along the top edge of the saw table to shim the router table down and even with the saw table from side to side (see Figure 10).

Note: After reinstalling the router table, remove all excess masking tape with a razor blade.

Tape

Figure 9. Using tape to shim the router

table up.

Tape

Figure 10. Positioning the tape to shim

the router table down.

-8-