Belt Tension Adjustment
The pump drive belt is
Replacing the Cutter Deck Belt
•Stop engine and remove the key and wait for all moving parts to stop.
•Remove deck covers
•Remove belt by using a ½” ratchet and extension to relieve belt tension.
Replacing Drive Belt
•Stop engine and remove the key and wait for all moving parts to stop.
•Remove deck covers.
•Remove drive belt access panel.
•Remove cutter deck engine to blade belt from clutch.
•Raise front of unit and secure
•Remove the clutch stop
•Remove belt by using a ½” ratchet and extension to relieve belt tension.
•Reinstall in reverse order. Figure shows belt configuration.
•NOTE: Ensure clutch stop is reinstalled.
14
Clutch
Stop
Deck Lift Assist Adjustment
•Loosen the DLA adjustment hardware.
•Using a 3/8” ratchet, make tension adjustments. Note: Too much spring tension
(easier to lift) may cause the deck to bounce.
Easier | Harder |
to lift | to lift |