Seat Adjustments
The Sport X seat is equipped with the ability to adjust the seat up and down as well as lock the seat in the down position to avoid seat bounce while standing. (Figure 1)
B
A
Figure 1
Height Adjustment:
•Loosen lower seat mounting hardware,
•Removing upper bolts. (Fig. 1A)
•Raise or lower seat to desired setting and
•Tighten all hardware.
Seat Lock:
•Loosen
•Slide up to top of slot and lock
•To fold seat forward, loosen
Hydro Oil Tank Check/Fill
Checking oil
•Ensure mower is on a level surface.
•Remove hex socket plug from oil level port on the front of the tank. Location is behind the engine attached to the front of the upright assembly.
•Hydro oil should be at the bottom of the threads. Filling oil
•Remove hex socket plug.
•Using a funnel, fill tank through oil level port until oil reaches bottom threads of the port.
15
Fill Here
Lubrication
Grease with No. 2 general purpose lithium base or molybdenum base grease.
•Set parking brake, stop the engine and remove the key.
•Clean grease fittings with a rag.
•Connect grease gun to fitting and pump until grease begins to ooze out from the bearings.
•Wipe off excess grease.
•Do not use spray lube of any kind on choke and/or throttle cables.
Service intervals: First 8 hours Every 25 hours
Also see Maintenance chart
How to Move the Mower if the Engine Won’t Start
Rotate both of the hydro bypass valves on the side of each hydraulic pump about ½ turn counterclockwise. It is important not to over tighten these. Damage may occur to the pump if this valve is over tightened.