Setting up the Lamp Module
Setting The Lamp Module’s Code (modules sold separately)
Using a small screwdriver, set the red House Code dial to the same letter as your Mini Timer. Set the Black Unit Code dial to any unused number.
Ratings
UNIT CODE
DIAL
HOUSE CODE
DIAL
The Lamp Module can be used to control an incandescent lamp rated up to 300W. It is NOT suitable for other types of lamps such as fluorescent or energy saving lamps, low voltage lamps, or lamps that include a dimmer control. Caution: Do not connect an appliance such as a coffee pot or heater to a Lamp Module. It may damage the Module and/or the appliance and could cause a fire hazard. Use an Appliance Module instead.
1. | Set the House | 2. | Plug a lamp into | 3. | Plug the Module into |
| Code and Unit |
| the Module. |
| the same wall outlet |
| Code. |
|
|
| as your controller (see |
|
|
|
|
| testing below). |
Testing The Lamp Module
Make sure the lamp's switch is on. Plug the Module into the same wall outlet as your Mini Timer, press the ON and OFF buttons on the Mini Timer that correspond to the Unit Code setting on the Module. If the Module turns On and Off you can unplug the Module or Mini Timer and move it to its permanent location. If you can’t control the module, contact www.x10.com/support for help.
14
