Manuals / Xantrex Technology / Computer Equipment / Switch

Xantrex Technology GT Series manual Configuring the LAN Interface, Installation and Configuration

Models: GT Series

1 26

Download 26 pages 15.19 Kb

Page 20

Image 20

Installation and Configuration

Figure 4 Ethernet Communications Kit Configuration Diagram

Configuring the LAN Interface

To configure the Ethernet Communications Kit (NPort Express) follow the instructions provided on the NPort Installation CD.

153553

For use by qualified technicians only

Page 20

Image 20

Xantrex Technology GT Series Configuring the LAN Interface, Ethernet Communications Kit Configuration Diagram, 153553

Contents

This guide for use by qualified personnel only GT Series Three Phase Ethernet Communications KitInstallation Guide Page This guide for use by qualified personnel only GT Series Three Phase Ethernet Communications KitInstallation Guide About Xantrex TrademarksNotice of Copyright Exclusion for DocumentationAbout This Guide PurposeScope AudienceThe following conventions are used in this guide Conventions UsedRelated Information Important Safety Instructions SAVE THESE INSTRUCTIONS - DO NOT DISCARDWARNING Shock Hazard WARNING Lethal VoltageRisks WARNING Amputation hazardWARNING Burn hazard CAUTION Equipment DamageGeneral Safety Precautions Personal SafetySafety Equipment Qualified PersonnelWARNING Shock Hazard Operational Safety ProceduresLockout and Tag AC Utility Terminals TB1-A, TB1-B, TB1-C, TB1-N, and TB2GND BUS PV Terminals TB3, TB4, and TB5 PV GNDDe-Energize/Isolation Procedure Interconnection Standards ComplianceIntended Use To isolate the InverterContents Installation and ConfigurationPage Interface Requirements Installation and ConfigurationDescription of the GT Series Three Phase Ethernet Communications Kit Installation De-Energize/Isolation Procedure Shutdown WARNING Shock hazardEquipment Required WARNING Shock hazardCommunications Kit Installing the Ethernet Communications KitUse the following procedure to install the new Ethernet Figure 2 Ethernet Kit Cable Connections Figure 3 CCU Board Cable ConnectionsConfiguring Energize Procedure StartupUse the following procedure to turn on the Inverter LAN Interface Set-upConfiguring the LAN Interface Figure 4 Ethernet Communications Kit Configuration DiagramInstallation and Configuration 153553Warranty and Return Information WarrantyDisclaimer ProductExclusions Return Material Authorization PolicyReturn Procedure Out of Warranty Service Page 153553 Revision A Xantrex Technology Inc1 800 670 0707 Tel toll free NA 1 408 987 6030 direct