■Follow all warnings and instructions marked on, or supplied with, the system, options and supplies.
Caution
Use of other than Genuine Xerox WorkCentre C2424 Solid Ink may affect print and copy quality and system reliability. It is the only ink designed and manufactured under strict quality controls by Xerox for specific use with this system. The Xerox Warranty, Service Agreements, and Total Satisfaction Guarantee do not cover damage, malfunction, or degradation of performance caused by use of
Note
The Total Satisfaction Guarantee is available in the United States and Canada. Coverage may vary outside these areas; please contact your local representative for details.
System Location
■Place the system in a
90 degrees F (10 degrees C to 32 degrees C) and a relative humidity range of 10 percent to 80 percent.
■Place the system in an area where there is adequate space for ventilation, operation, and servicing. The recommended minimal spacing is:
■30 cm (11.8 in.) above, measuring from the top of the document feeder
■24 cm (9.5 in.) behind
■10 cm (3.9 in.) on the left side of the system
■37 cm (14.6 in.) on the right side of the system, to allow access to the maintenance unit and waste tray.
■Do not block or cover the slots and openings on the system. The system may overheat without adequate ventilation.
■
■
■
■
■
■
For optimum performance, use the system at elevations below 2,438 m (8,000 ft.).
Do not place the system on a carpeted location such as a carpeted floor. Airborne carpet fibers can be pulled into the system and cause print- and
Do not place the system near a heat source. Do not place the system in direct sunlight.
Do not place the system in line with the cold air flow from an air conditioning system. Place the system on a level, solid
WorkCentre® C2424
