
The Document Company
XEROX
DC220/230ST CentreWare® Internet Services Quick Install
The Xerox DC220/230ST contains an | 1. Connect the DC220/230 to your network | ||
embedded Web Server. CentreWare Internet | outlet or cable. | ||
Services contains tools within the Web Page | 2. Enter System Administrator Setups: | ||
that allow users to check the status of the | |||
queue, submit print ready files as print jobs, | a) | Press the [Access] button on the | |
scan jobs, configure scanning templates, etc. | |||
| Control Panel. | ||
|
| ||
In addition, after Internet Services is enabled, | b) | Enter the System Administrator | |
machine network configuration and setup can be | |||
| password by typing #22222 | ||
accomplished from the System Administrator’s |
| ||
| (# key and 22222) on the keypad and | ||
desktop (password required). |
| ||
| pressing [Enter] on the screen. | ||
|
| ||
Before Installation: |
| Note: #22222 is the factory default | |
Record the following information for use during |
| password and may be changed by | |
| your Xerox service representative to | ||
setup at the DC220/230: |
| suit your needs. | |
TCP/IP Address:_________________________ | 3. Access the TCP/IP Network Setups | ||
Gateway Address:_______________________ | screen: | ||
a) |
| ||
Subnet Address:_________________________ | On the screen display, press [Print | ||
| Setups]. | ||
|
| ||
Broadcast Address:______________________ | b) | Press [Network Setups]. | |
Host Name:_____________________________ | c) | Press [TCP/IP]. If TCP/IP has been | |
A minimum configuration of Microsoft Internet |
| enabled and configured, skip to step 4. | |
|
| ||
Explorer® 4.x or higher, or Netscape Navigator® |
|
| |
3.x or higher should be used. Other browsers |
|
| |
may work, but may not produce expected |
|
| |
results. |
|
| |
|
|
|
For assistance, contact your local Xerox Customer Support Center:
USA:
d)IP Address setup (skip this step if using RARP): Press [IP Address], then press [Edit] and use the key- board on the display screen to enter the static IP address for the DC220/ 230. This number is assigned by the System Administrator
OR
d)RARP setup (skip this step if using a static IP address): Press [RARP], then press [Enabled].
e)Press [Save].
f)Press [Gateway Address], then press [Edit] and use the keyboard on the display screen to enter the Gateway address of your network.
g)Press [Save].
h)Press [Subnet Mask], then press [Edit], and use the keyboard on the display screen to enter the Subnet Mask for your network (default is 255.255.255.0.
i)Press [Save].
Over