The Document Company
XEROX
DC220/230ST CentreWare® Internet Services Quick Install
j)Press [Broadcast Address], then press [Edit] and use the keyboard on the display screen to enter the Broadcast Address of your network.
Note: The Broadcast Address is the address where all host bits are set to either zero (0) or one (1).
k)Press [Save].
l)Press [Host Name], then press [Edit] and use the keyboard on the display screen to enter the Host Name you want your DC220/230 to use.
m)Press [Save].
n)Press [Save] on the TCP/IP screen to save all the network settings.
o)Press [Exit] on the Network Setups screen.
4.Press [Additional Setups] in the upper right corner of the screen.
5. Press [HTTP].
6. Enable HTTP:
a)Press [Enablement].
b)Press [Enabled].
Note:The Port Number and the Maximum Num- ber of Connections are predetermined.
7. Press [Save].
8. Press [Exit] on the Network Setups screen. The DC220/230 will reboot and print a configuration sheet in approxi- mately 3 minutes.
9. Check the settings on the configuration sheet against those that were entered.
10. At a client workstation on the network, open the Internet Browser.
11. In the URL field, enter http:// followed by the IP address of your DC220/230. Example: If the IP address is 127.0.0.1, the URL would be http://127.0.0.1.
Refer to the CentreWare manual, Getting Started with Print and Fax Services for addi- tional information.
Additional information on network installation can be found in the DC220/230 System Administration Guide.
For assistance, contact your local Xerox Customer Support Center: | ©1998 Xerox Corporation |
USA: | 701P97996 Version 1.1, |
