Standard Features | English |
|
Subsonic Filter
24dB/Octave Variable
Fully Regulated PWM Power Supply
All Xtant “A” Series amplifiers feature a Fully Regulated, Pulse Width Modulated power supply. This supply technology provides high efficiency and consistent output performance even when battery voltage is less than optimum.
Crossover
A 24dB/Octave low pass filter network with variable
Balanced/Floating Input
When enabled, this circuitry helps to eliminate “system noise” associated with “ground loops”. When combined with the input sensitivity adjustment, it allows the A Series to accept up to 17V of input signal. Balanced must be used for BTL inputs using the HLA.
Protection Circuitry
Both Thermal and Overcurrent protection are incorporated into the “A” Series Amplifiers. In the event of a problem, the amplifier will reduce its power to maintain operation.
Status LEDs (Located on the top of the amplifiler)
Three LEDs, indicate operational status of all Xtant A Series amplifiers. The red LED illuminates when the amplifier is “ON”, the yellow LED indicates that overcurrent protection is engaged, the orange LED indicates that the thermal protection circuit is engaged.
Optional Performance Upgrades
High Level Adapter (HLA)
This adapter allows you to connect a source unit with speaker level outputs to your Xtant amplifier.
Remote Level Control (RLC)
The RLC or Remote Level Control allows a remote bass control to be adjusted from the driver’s seat.
English | Xtant A3001 Specifications | ||
|
|
| |
Frequency Response: |
| 20 Hz to 120 Hz +/– 1 dB | |
Number of Channels: |
| 1 | |
Watts per Channel @ 4Ω | : | 1 x 150 | |
Watts per Channel @ 2Ω | : | 1 x 300 | |
Recommended Load: |
| ≥ 2Ω | |
Distortion (THD): |
| ≤ 2% | |
Measured: 20 Hz to 120 Hz at rated power, all channels driven 4Ω | |||
Signal to Noise Ratio: |
| ≥ 100 dB | |
Measured: | |||
Damping Factor: |
| ≥ 100 @ 100 Hz with 4Ω load | |
Input Sensitivity: |
| 100 mV to 8.5 V RMS Unbalanced | |
|
|
| 200 mV to 17 V RMS Balanced |
Input to Line Output Gain: |
| 0 dB | |
| 24 dB/Octave Low Pass | ||
Balanced Line: |
|
| On Board |
Power Supply: |
| Fully Regulated, PWM | |
Operational Voltage: |
| 10 to 16 Volts | |
Fusing Requirement: |
| 40 Amp | |
Size (L xW x H): |
| ||
|
|
| 295mm x 235mm x 47mm |
Subsonic Filter: |
| 24 dB/Octave | |
Bass Boost: |
|
| |
Warranty: |
|
| Limited 4 Year Parts and Labor |
|
|
| (See page 8 for details) |
4 | 5 |