Yamaha 502, CDC-902 ■Manual tape programming, 12, TAPE, PROG, PEAK, PLAY, PLAY, PLAY, PAUSE, Notes, SYNCHRO, select a, Select a, DISC SKIP, If necessary, desired disc

■Manual tape programming

This is for recording desired tracks selectedfrom one or more discs in any desired order onto tape.

1 Stop the unit.

STOP

2 If you will select tracks from a disc (or discs) other than the disc on the Disc 1 tray, make this unit display the total recorded time of each disc to be used by pressing the DISC SKIP button in turn.

*This unit will read the contents of a disc by this operation. If there is a disc to which this operation is omitted, tracks on the disc cannot be programmed.

3 Follow step 4 and 5 on page 18.

4	PROG	PROG
		TOTAL
		REMAIN
5	If necessary,	DISC SKIP
	select a
	desired disc.
6	Select a	5
	desired track.

7 Repeat step 5 and 6 to program more tracks for side Aof the tape. You can select the same track again.

*If “E rr” appears on the display, the track number just selected cannot be programmed because there is no enough time remaining on side A of the tape.

8 When you finish the programming for side A, program the pause mode by pressing the TAPE button.

TAPE

*“Pu” flashes on the display, and after then you can begin programming for side B.

	SYNCHRO		DIMMER	TIME	OPEN/	English
8	SYNCHRO		DIMMER	TIME	CLOSE	4, 11
8	1	2	3	CLEAR	INDEX	4, 11
			TAPE	CLEAR	PROG
6	4	5	6		+I0
6	7	8	9		0
2, 5	DISC SCAN MODE REPEAT RANDOM					13
	DISC SKIP			SEARCH
	– OUTPUT LEVEL +			SKIP
1		STOP	PAUSE	PLAY		12, 13
1						12, 13

9 Follow step 5 and 6.10 Repeat step 5 and 6 to program more tracks for side B of the tape.You can select the same track again.

*If “E rr” appears on the display, the track number just selected cannot be programmed because there is no enough time remaining on side B of the tape.

11 The peak level searching function of this unit is useful for adjusting recording level on the tape deck. For peak level searching, when the programming for side B is finished, press the PROG button and then press the PEAK button on the front panel. (Refer to page 21.)

12 Begin recording on the tape deck and press the PLAY button on this unit at the same time.

13 The unit will pause at the end of side A of the tape. Turn the tape over to side B. Resume recording and, at the same time, press the PLAY or PAUSE button on this unit.

Notes

●In step 7 and 10, even if “E rr” appears on the display, you can program another track of which time is shorter than the remaining time on the side of the tape. At this time, if any other track number is flashing continuously on the display, you can program it.

●CD synchronized recording function can be used if your tape deck is compatible with it.

In this case, in step 12 and 13, press the SYNCHRO button and then press the PLAY button on this unit’s remote control transmitter. Recording automatically begins.

(For details, refer to page 17.)Notes on tape programming●To check, cancel or correct program data, refer to page 15.

●The maximum number of tracks that can be programmed is 40. If, however, the PAUSE mode is inserted, it is counted as one track.

●This function can be used to program up to track number 20. If the disc has more than 20 tracks, track number 21 and thereafter will not be programmed.