CONNECTIONS

(RED)

The back of the

Subwoofer

 

(RED)

Connector

Color tube

(RED)

(BLUE)

Connector

(BLUE)

Color tube

(BLUE)

y

•The connector of the included speaker cable and the terminal of the subwoofer are classified by color. Connect a connector to the terminal of the same color.

•The label of the speaker is attached to each speaker cable. Connect the speakers in accordance with the labels.

•Connect the color tube of the speaker cable to the plus (+) side of each speaker. If the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass.

•A cover is attached to the end of the speaker cable. Connect the speakers after removing the cover.

•Make sure that the plugs of the system control cable and the connectors of the speaker cables are inserted correctly before inserting them.

Notes

•Do not let the bare speaker wires touch each other or any metal part of this system. This could damage this system and/or the speakers.

•Do not insert the plug or connector forcibly. Doing so may damage the plug, connector or terminal.

•Do not scratch, forcibly bend, or pull the system control or speaker cable as this may damage the cable, causing loss of audio output, and may possibly result in a fire or electric shock. Take particular care in making sure that the cable is not squashed by a rack or caster.

•Before disconnecting or connecting the system control cable, disconnect the power supply cord of the subwoofer and AV receiver.

■Using commercially available speakers and speaker cables

You can use commercially available speaker cables and speakers except for a subwoofer. If you use them, note the following.

•Use the speaker whose impedance is 6Ω or higher.

When using the speaker whose impedance is lower than 6Ω, the protection circuit may start working or this system may be damaged.

•Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the speakers away from the monitor.

•Use the speaker cable that is as thick as the included cable. Too thick cables cannot be used.

Exchanging the speaker cables

2Tab

3

1

15 mm

4

1 Remove approximately 15 mm (9/16”) of insulation from each of the speaker cables.

Twist the exposed wires of the cable together to prevent short circuits.

2 Open the tab.

3 Pull the inserted bare wire of the speaker cable from the connector and insert the bare wire of the commercially available speaker cable.

4 Return the tab to secure the wire.

16