Troubleshooting
Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, turn off this unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center.
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
|
|
|
| |
This unit fails to turn | The power cable is not connected to the AC IN | Connect the power cable firmly. | 15 | |
on. | inlet on the rear panel or not plugged in the AC |
| ||
| wall outlet. |
|
| |
|
|
|
| |
The disc tray does not | A foreign object is obstructing the tray. | Carefully check the disc tray and remove the | — | |
close completely. |
| foreign object. | ||
|
| |||
|
|
|
| |
Playback does not | The disc is damaged. | Check the disc carefully; replace it if necessary. | — | |
start. |
|
|
| |
There is moisture on the laser pickup. | Wait 20 to 30 minutes after switching on the unit | — | ||
| ||||
|
| ON before trying to play back a disc. | ||
|
|
| ||
|
|
|
| |
| The disc is loaded upside down. | Reload the disc with the label side up. | — | |
|
|
|
| |
| The disc is dirty. | Clean the disc. | 20 | |
|
|
|
| |
| The MP3 or WMA formats are not compatible | Replace the disc with a correctly recorded disc | 20 | |
| with this unit. | playable with this unit. | ||
|
| |||
|
|
|
| |
| The | Replace the disc with a correctly recorded disc | 19 | |
| correctly. | playable with this unit. | ||
|
| |||
|
|
|
| |
| The disc is a | Replace the disc with a correctly recorded disc | 19 | |
| this unit. | playable with this unit. | ||
|
| |||
|
|
|
| |
Playback is delayed, | The disc may be scratched or damaged. | Check the disc carefully; replace it if necessary. | 20 | |
or begins at the |
|
| ||
wrong place. |
|
|
| |
|
|
|
| |
No sound. | Improper output cable connections. | Connect the cables properly. If the problem | 14 | |
|
| persists, the cables may be defective. | ||
|
|
| ||
|
|
|
| |
| Improper amplifier operation. | Set the amplifier controls to the correct input | — | |
|
| selection. | ||
|
|
| ||
|
|
|
| |
Sound of a | PURE DIRECT is turned on. | Turn PURE DIRECT off. Or make an analog | 6 | |
component |
| connection. | ||
|
| |||
connected to the |
|
|
| |
Super Audio CD layer is playing. | Switch the playback layer. Or make an analog |
| ||
DIGITAL OUT jacks is | 6, 10 | |||
not played. |
| connection. | ||
|
| |||
|
|
|
| |
Sound “skips”. | This unit is being subjected to vibrations or | Relocate this unit. | — | |
| impacts. |
| ||
|
|
| ||
|
|
|
| |
| The disc is dirty. | Clean the disc. | 20 | |
|
|
|
| |
Sound “hums”. | Improper cable connections. | Securely connect the audio cables. If the problem | 14 | |
|
| persists, the cables may be defective. | ||
|
|
| ||
|
|
|
| |
Noise from a nearby | The tuner is too close to this unit. | Move the tuner and this unit farther apart. | — | |
tuner. |
|
| ||
|
|
| ||
|
|
|
| |
Noise from inside of | The disc may be warped. | Replace the disc. | — | |
the disc tray. |
|
| ||
|
|
| ||
|
|
|
|
English
