TROUBLESHOOTING
Problems | Possible Causes | Solutions | Refer to | |
page | ||||
|
|
| ||
|
|
|
| |
Sound “skips”. | This unit is being subjected to vibrations or | Relocate this unit. | — | |
| impacts. |
| ||
|
|
| ||
|
|
|
| |
| The disc is dirty. | Clean the disc. | ||
|
|
|
| |
Sound “hums”. | Improper cable connections. | Securely connect the audio cables. If the | ||
|
| problem persists, the cables may be defective. | ||
|
|
| ||
|
|
|
| |
Noise from a nearby | The tuner is too close to this unit. | Move the tuner and this unit farther apart or turn | — | |
tuner. |
| off this unit. | ||
|
| |||
|
|
|
| |
Noise from inside of | The disc may be warped. | Replace the disc. | — | |
the disc tray. |
|
| ||
|
|
| ||
|
|
|
| |
The remote control | Wrong distance or angle. | The remote control functions within a |
| |
does not work or |
| maximum range of 6 m (20 ft) and no more than | ||
function properly. |
| 30 degrees |
| |
|
|
|
| |
| Direct sunlight or lighting (from an inverter type | Reposition this unit. |
| |
| of fluorescent lamp, etc.) is striking the remote |
| — | |
| control sensor of this unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries. | ||
|
|
|
|
SPECIFICATIONS
Audio Section
• Frequency response ..................................... | 2 Hz - 20 kHz, ± 0.5 dB |
• Harmonic distortion + noise (1 kHz)......................... | 0.003 % or less |
• S/N ratio.................................................................... | 105 dB or more |
• Dynamic range............................................................ | 96 dB or more |
• Output voltage (1 kHz, 0 dB) ........................................... | 2.0 ± 0.3 V |
Laser Diode Properties
• Material.................................................................................. | GaAlAs |
• Wavelength ............................................................................. | 790 nm |
• Laser Output .............................................................. | max. 1.23 μW* |
*This output is the value measured at a distance of about 200 mm from the objective lens surface on the Optical
General
• Power requirements |
|
U.S.A. and Canada models | .............................. AC 120 V, 60 Hz |
Australia model ................................................ | AC 240 V, 50 Hz |
Europe and U.K. models .................................. | AC 230 V, 50 Hz |
Asia and General models ...... | AC |
China model ..................................................... | AC 220 V, 50 Hz |
• Operating temperature............... | +5 °C to +35 °C (+41 °F to +95 °F) |
• Power consumption................................................................... | 13 W |
• Dimensions (W × H × D)................................... | 435 × 86 × 260 mm |
| (17 1/8 × 3 3/8 × 10 1/4 in) |
• Weight ........................................................................ | 3.5 kg (7.7 lbs) |
Please note that all specifications are subject to change without notice.
iPod™
“iPod” is a trademark of Apple Inc., registered in U.S. and other countries.
“Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
English