CONNECTIONS

English

●Before making any connections, switch OFF the power to the unit and the amplifier or other component.

●Connections should be made to the correct input terminals of the amplifier or other component.

CDC-565

LINE OUT

To AC outlet

➊ Connection cord (included)

➊ Connection cord (included)

●If the placement of this unit causes noise to other equipment, such as a tuner, separate them from each other.

CDC-765, CDC-665

LINE OUT

DIGITAL

 

AUDIO

 

OUT

 

OPTICAL

To AC outlet

➋Optical fiber cable (not included)Amplifier

OPTICAL

CD

DIGITAL IN

Choose one of the ways listed below to connect this unit to your amplifier.
When the LINE OUT (analog) terminals of this unit are used ( ➊ )

●Be sure that the left (“L”) and right (“R”) LINE OUT terminals are connected to the corresponding (left and right) terminals of the amplifier or other component.

●Connect the “LINE OUT” terminals to the “CD” (or “AUX”) terminals of the amplifier. If the amplifier does not have such terminals, use the “TAPE PB” terminals. For additional details concerning these connections, refer to the operation instructions for the amplifier being used.

●CDC-765 and CDC-665 only

Adjust the level of signals output into an amplifier, etc. by using the OUTPUT LEVEL button.

CDC-765 and CDC-665 only

When the DIGITAL AUDIO OUT (OPTICAL) terminal of this unit is used ( ➋ )●Before using this terminal, remove the terminal’s cover by pulling it.

●Make the connection from this terminal to the optical input terminal of an amplifier by using a commercially available optical fiber cable.

*Use an optical fiber cable that conforms to EIAJ standards. Other cables might not function correctly.

●Be sure to attach the terminal’s cover when this terminal is not being used, in order to protect the terminal from dust.

●Set the level of signals output into an amplifier to max. by using the OUTPUT LEVEL button.

●This terminal can also be connected to the optical input terminal of a digital audio tape deck (DAT) etc. to record CD onto tape directly.

For Custom Installer For U.S.A. and Canada models of CDC-765 onlyREMOTE CONTROL (IN, OUT) terminals
These terminals are used for custom installation system.By connecting the REMOTE CONTROL OUT terminal of
When this unit is connected to the components for custom

this unit to the REMOTE CONTROL IN terminal of the other

installation system, you can operate this unit with the

component, you can also operate it with the system remote

system remote control.control. In this way, up to 6 components can be connected
Connect the REMOTE CONTROL IN terminal of this unit toin series.
the output terminal of the central controller for custom

 

installation system.

 

5