TROUBLESHOOTING
If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help.
| SYMPTOM | PROBABLE CAUSE | REMEDY |
|
|
|
| The player does not switch ON when | The power cord is not connected or not | Securely connect the power cord. |
| the STANDBY/ON switch or POWER | completely connected. |
|
| button is pressed. | Front panel is open. | Close the front panel securely. |
|
|
|
| This unit does not work normally. | There is an influence of strong external | Turn the power off and disconnect the |
| noise (lightning, excessive static | AC power from the AC outlet. After about |
| electricity, etc.) or a misoperation was | 30 seconds, connect the power and try |
| performed while using this unit. | again. |
| Play does not begin. | The disc is damaged. | Check the disc carefully; replace it if |
|
| necessary. |
| There is moisture on the laser pickup. | Wait 20 to 30 minutes after switching the |
|
| unit ON before trying to play a disc. |
| The disc has been loaded backwards. | Reload the disc with the label side facing |
|
| right. |
|
|
|
| The disc is dirty. | Clean the disc. |
|
|
|
| Play is delayed, or begins at the | The disc may be scratched or damaged. | Check the disc carefully; replace it if |
| wrong place. |
| necessary. |
|
|
|
| No sound. | Improper output cable connections. | Connect the cables properly. If the |
|
| problem persists, the cables may be |
|
| defective. |
|
|
|
| Improper amplifier operation. | Set the amplifier controls to the correct |
|
| input selection. |
|
|
|
| Sound “skips.” | The player is being subjected to | Relocate the player. |
| vibrations or impacts. |
|
| The disc is dirty. | Clean the disc. |
|
|
|
| Sound “hums.” | Improper cable connections. | Securely connect the audio cables. If the |
|
| problem persists, the cables may be |
|
| defective. |
|
|
|
| Noise from a nearby tuner. | The tuner is too close to the player. | Move the tuner and player farther apart. |
| Noise from inside of the unit. | The disc may be warped. | Replace the disc. |
|
|
|
| “TAKE OUT” appears in the display. | A disc is set in the slot of the disc being | Remove the disc from the currently |
| played. | playing disc’s slot. |
|
|
|
| The unit fail to work properly due to | Open and close the front panel while the |
| some external lighting or sound stimulus. | unit is turned on to reset the unit. |
|
|
|
| The remote control transmitter does | The batteries of the remote control | Replace the batteries with new ones. |
| not work. | transmitter are too weak. |
|
| Direct sunlight or lighting (of an inverter | Change the position of the main unit. |
| type of fluorescent lamp etc.) is striking |
|
| the remote control sensor of the main |
|
| unit. |
|
| Front panel is open. | Close the front panel securely. |
|
|
|
24