Chapter 2 - Installing the Yamaha CDR400At Drive

4.Remove the front cover of a vacant half-height drive bay.

For details refer to the manual of your computer.

5.Remove the SCSI card, and set the terminator setting of the SCSI internal circuit to the position for internal connected devices. For details refer to the manual of your SCSI card.

6.Slide the CDR400At drive into the drive bay from the front.

At this time, be careful not to apply excessive force to the drive itself. Finger-tighten the four fastening screws, and check that there is enough room to connect the power supply cable, SCSI cable, and AUDIO cables.

7.Connect the SCSI flat cable.

Connect the 50-pin SCSI flat cable to the SCSI card and to the SCSI interface located on the rear panel of the CDR400At drive.

Position the connector so that the colored line is at pin 1 (your lower right).

9