Troubleshooting
If CDR400At is not performing as expected, look up the symptoms in the following table, and take the appropriate corrective action.
Symptoms | Corrective action |
|
|
The power to the CDR400At is off | • Check the DC power cable connection. |
|
|
The power to the computer is off | • Check to see if the SCSI card is correctly installed. |
|
|
The CDR400At is not recognized by | • Check the SCSI cable connection. |
the computer | • Make sure that SCSI ID numbers are assigned |
| |
| exclusively. |
| • Make sure that the last device in the SCSI daisy |
| chain is terminated correctly. |
|
|
The CDR400At does not operate | • Install the SCSI driver software again. |
correctly |
|
|
|
The disc tray will not open | • Make sure that the power to the drive is turned on. |
|
|
The disc ejects | • Make sure that the disc is seated in the tray cor- |
| rectly. |
|
|
Incorrect operation | • Make sure that the disc is seated in the tray cor- |
| rectly. |
| • Make sure that you are using the correct disc. |
| • Make sure that there is no dust, dirt, or conden- |
| sation on the disc or tray. |
|
|
17