Yamaha CDX-E100 E100, CAUSE, REMEDY, SYMPTOM, RECEIVER, To prevent a malfunction of this unit

ADDITIONAL INFORMATION

CD preventive care

•This compact disc player is designed for playing

compact discs bearing the or mark only. Never attempt to load any other type of disc into the unit.

The unit will also play 8-cm (3-inch) compact discs.

•Compact discs are not subjected to wear during play, but damage to the disc surface when the disc is being handled can adversely affect the disc’s play.

•Do not use cleaning discs or warped discs. All of these could damage the unit.

To prevent a malfunction of this unit

•Do not use any non standard shaped CD (heart, etc.) available on the market, because it may damage the unit.

•Compact discs are not affected by small particles of dust or fingerprints on their playing surface, but even so they should be kept clean. Wipe by using a clean, dry cloth. Do not wipe with a circular motion; wipe straight outward from the center.

•Do not try to clean the disc’s surface by using any type of disc cleaner, record spray, antistatic spray or liquid, or any other chemical-based liquid, because such substances might irreparably damage the disc’s surface.

•Do not expose discs to direct sunlight, high temperature or high humidity for a long period of time, because these might warp or otherwise damage the disc.

No!

• Do not use a CD with tape, seals, or paste on it, because damage to the unit may result.

Troubleshooting

If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. When taking the service, the MDX-E100 or KX-E100 may be needed. For details, contact your authorized YAMAHA dealer or service center.

	SYMPTOM	CAUSE	REMEDY
	The unit does not switch ON when	The AC power cord is not connected or not	Securely connect the power cord.
RECEIVER	the STANDBY/ON switch is pressed.	completely connected.
	No sound from one speaker.	Loose speaker connections.	Connect properly.
	No sound from speakers.	Internal protection circuit is functioning.	Unplug the AC power cord from the wall outlet, and
			then plug in again.
E100
	No sound from an external unit	Incorrect cord connections.	Connect the cords properly. If the problem persists,
-	connected with this unit or play does		the cords may be defective.
RX
	not begin.
		Input source selection is not proper.	Make a proper input source selection.

E-26