Yamaha CLP-411, CLP-511 F6.5/F8.5: Control Change ON/OFF , F6.6/F8.6: MIDI T ransmit Transpose, F6.7/F8.7: Panel/Status T ransmit, F6.8/F8.8: Bulk Data Dump

The Function Mode

F6.5/F8.5: Control Change ON/OFF ........................................................................................

Normally the Clavinova will respond to MIDI control change data received from an

external MIDI device or keyboard, causing the voice on the corresponding channel to be

affected by pedal and other “control” settings received from the controlling device (the key-

board voice is not affected, but reverb depth data will affect the Clavinova settings). The

Clavinova also transmits MIDI control change information when one of its pedals or other

appropriate controls are operated.

This function makes it possible to cancel control change data reception and transmission so

that, for example, the Clavinova pedals and other controls can be operated without affecting

an external MIDI device.

Use the [–/NO] and [+/YES] buttons to turn control change transmission and reception

“On” or “OFF”.

Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting: “On”.

F6.6/F8.6: MIDI Transmit Transpose.......................................................................................

This function allows the MIDI note data transmitted by the Clavinova to be transposed up

or down in semitone increments by up to plus or minus 12 semitones. The pitch of the

Clavinova itself is not affected.

Use the [–/NO] and [+/YES] buttons to set the desired amount of MIDI transmit transposi-

tion. The range is from “–12” (down one octave) through “0” (no transposition) to “12” (up

one octave).

Press the [–/NO] and [+/YES] buttons simultaneously to recall the default setting: “0”.

F6.7/F8.7: Panel/Status Transmit...............................................................................................

This function causes all the current Clavinova control settings (selected voice, etc.) to be

transmitted via the MIDI OUT terminal. This is particularly useful if you will be recording

performances to a MIDI sequence recorder such as the Yamaha DOU-10 Disk Orchestra Unit

which will be used to control the Clavinova on playback. By transmitting the Clavinova panel

settings and recording them on the MIDI sequence recorder prior to the actual performance

data, the Clavinova will be automatically restored to the same settings when the performance

is played back.

Press the [+/YES] button to transmit the panel/status data. “End” will appear on the LED

display when the data has been successfully transmitted.

NOTE

•See page 45 for list of the “Panel Data Contents” transmitted by this function.

•Panel setting data can only be transferred between the same models (i.e. CLP-411 data cannot be

dumped to a CLP-511, and vice versa.

F6.8/F8.8: Bulk Data Dump...............................................................................................................

This function is used to transmit all data stored in the Recorder memory to a MIDI data

storage device such as the Yamaha DOU-10 Disk Orchestra Unit, other sequence recorders, or

MIDI compatible computers.

Press the [+/YES] button to begin bulk transmission. “End” will appear on the LED

display when the data has been successfully transmitted.

NOTE

•Bulk dump will not function when the recorder is in operation.

•Recorder data can only be transferred between the same models (i.e. CLP-411 data cannot be

dumped to a CLP-511, and vice versa.

•No MIDI note/panel data transmission or data reception occurs during a bulk dump transmit opera-

tion.