Yamaha CRW4261t, CRW4261t-NB manual 12

Chapter 2 - Installing the Yamaha CRW4261t Drive

Setting the CRW4261t as the MASTER

As shown in the diagram at the right, insert the jumper pin into the right edge of the jumper switch.

Note: If only the CRW4261t will be connected to the IDE interface connector, connect the CRW4261t to the end of the connector.

Setting the CRW4261t as the SLAVE

As shown in the diagram at the right, insert the jumper pin into the middle of the jumper switch.

CSEL (Cable SELect)

CSEL

SLAVE MASTER

CSEL

SLAVE MASTER

If you use the CSEL setting, the MASTER/SLAVE setting will be made automatically depending on the hardware configuration.

For details refer to the manual of your computer.

6