CV820WB Owner’s Manual
Changing the Locking Blocks
■CV820WB Control System
Bridge Pickup
Neck Pickup
| Pickup Selector |
Neck Pickup Volume | Neck Pickup |
| |
Bridge Pickup Volume | Mix |
| Bridge Pickup |
■About Wes Borland’s String Gauges
The CV820WB is the Wes Borland signature guitar model.The unique string gauges and tunings used by Wes Borland are given below.
Sting | Tuning | Gauge | |
|
|
|
|
| 1st | C# | .011 |
| 2nd | G# | .014 |
| 3rd | E | .022 (Wound) |
| 4th | B | .032 (Wound) |
| 5th | F# | .042 (Wound) |
| 6th | C# | .052 (Wound) |
The guitar is strung
1 Remove the old strings. (Refer to the “Removing the old strings”5 Set the locking bolt. section in the FC Tremolo System Manual.)
2 Loosen the FC nut locking lever, and remove the locking lever.
Loosen | 6 |
|
FC Nut Part Names
FC Nut
*1 : About locking blocks 1 and 2
FC Nut Components
Locking Block 1: for strings
Locking Block 3 (x1)
Locking Bolt (x1)
Locking Block 2: for strings
Locking Lever x1
3 Remove the locking bolt. |
Tighten |
7 This completes locking block replacement. Install the new strings |
and tune the guitar. (Refer to the “Installing the new strings” section |
Included with the guitar is a set of locking blocks that fit the string gauges used by Wes
Borland. Please note that the width of each locking block is different.
| For Normal Gauge Strings | Supplied Replacement: For Wes Borland Gauge |
| ||
| Fingerboard side | Fingerboard side |
| Head side | Head side |
Locking Block 1 |
|
|
6.8 mm wide | 6.6 mm wide | |
| (0.268 inch) | (0.260 inch) |
| Marked “1” | Unmarked |
| Fingerboard side | Fingerboard side |
| Head side | Head side |
Locking Block 2 |
|
|
6.2 mm wide | 6.0 mm wide | |
| (0.244 inch) | (0.236 inch) |
| Marked “2” | Unmarked |
in the FC Tremolo System Manual.) |
4 Replace the locking blocks 1 and 2.
*Set the wider blocks for the
*Set the narrower blocks to the
*Store the set of locking blocks you removed from the guitar in a safe place for future use.