CVP-203: Keyboard Stand Assembly

CVP-205/203
156
5Fix the main unit.
1Center the main unit to
produce equal clearance on
the left and right sides.
2Use 6x16 mm short screws to
secure the main unit from the
front.
6Connect the pedal cord.
7Set the voltage selector and connect the power
cord.
Voltage Selector
Before connecting the AC power cord, check the setting
of the voltage selector which is provided in some areas.
To set the selector for 110V, 127V, 220V or 240V main
voltages, use a “minus” screwdriver to rotate the
selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the
AC power cord to the AC INLET and an AC wall outlet.
A plug adaptor may be also provided in some areas to
match the pin configuration of the AC wall outlets in
your area.
WARNING
•An improper voltage setting can cause serious damage to the
Clavinova or result in improper operation.
8Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.

■After completing the assembly, please

check the following.

1Insert the pedal
cord plug to the
pedal connector
from the front.
2Attach the cord holders
to the rear panel as
shown, then clip the
cord into the holders.
3Use a vinyl tie
to take up any
slack in the
pedal cord.
240
127
110
220
• Are there any parts left over?
→Review the assembly procedure and correct
any errors.
• Is the Clavinova clear of doors and other
movable fixtures?
→Move the Clavinova to an appropriate
location.
• Does the Clavinova make a rattling noise when
you shake it?
→Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
→Turn the adjuster so that it is set firmly against
the floor.
• Are the pedal and power cords inserted securely
into the sockets?
→Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the
assembly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold the bottom of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper han-
dling can result in damage to the instrument or personal
injury.
Top portion
Key cover