Yamaha 205M, CVP-205 CVP-205/205M: Keyboard Stand Assembly, 2, 1, 3, 4, 5

153
CVP-205/203
CVP-205/205M: Keyboard Stand Assembly
CAUTION
■ Be careful not to confuse parts, and be sure to install
all parts in the correct direction. Please assemble in
accordance with the sequence given below.
■ Assembly should be carried out by at least two persons.
■ Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can cause damage.
■ Be sure to tighten up all screws upon completing
assembly of each unit.
■ To disassemble, reverse
the assembly sequence
given below.
1Open the package, take out the pedal box, take out
the styrofoam pads, and place the main unit on top
of the pads.
Position the pads so that they will protect the headphone
jack and the connector panel located underneath the front
left corner, and the floppy disk drive located underneath
the front right corner.
Remove the parts shown below from the box.
2Attach the side panels to the pedal box.
3Attach the front panel.
1Align and attach the front panel to the front side of the pedal box
and both side panels.
2Secure the panel using the 4x14mm thin screws.
* Insert six screws into the smaller holes on the brackets.
4Mount the main unit.
Be sure to place your hands at least 10 cm from either
end of the main unit when positioning it.
5Fix the main unit.
1Center the main unit to produce equal clearance on the left and
right sides.
Connector panel
Floppy disk drive
Phones jacks Styrofoam pads
Main unit
Front panel
Rear panel
Pedal box
Side panel
(left)
Assembly Parts AC power cord
Side panel
(right)
Pedal cord
6 x 25 mm long screws x4
4 x 20 mm tapping screws x5
6 x 16 mm short screws x4
Cord holders x24 x 14 mm thin screws x8
Side panel
(left)
Side panel
(right)
Side panel
(left)
Side panel
(right)
2Remove the vinyl tie from the folded
pedal cord. Do not
remove the vinyl tie
located next to the
hole.
1
Use the four 6x25 mm
long screws to attach the
pedal box. First attach one
side panel, then attach the
other side panel .
CAUTION
•Fingers can become pinched between the main unit and
the rear or side panels, be extra careful so as not to drop
the main unit.
•Do not hold the keyboard in any position other than the
position shown in the illustration.
At least
10 cm
At least
10 cm
2Use 6x16 mm short
screws to secure the
main unit from the rear.
* Use the front hole on
the front brackets to
attach the screws.
Have a Phillips-head (+)
screwdriver ready.