CVP-205/205M: Keyboard Stand Assembly

CVP-205/203
154
6Connect the speaker cord.
1Before connecting the speaker cord, remove the vinyl tie
attaching the speaker cord to the front panel.
2Insert the speaker cord plug into the connector, with the plug’s
tab facing the rear.
7Connect the pedal cord.
8Attach the rear panel.
9Set the voltage selector and connect the power
cord.
Voltage Selector
Before connecting the AC power cord, check the setting
of the voltage selector which is provided in some areas.
To set the selector for 110V, 127V, 220V or 240V main
voltages, use a “minus” screwdriver to rotate the
selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the
AC power cord to the AC INLET and an AC wall outlet.
A plug adaptor may be also provided in some areas to
match the pin configuration of the AC wall outlets in
your area.
WARNING
•An improper voltage setting can cause serious damage to the
Clavinova or result in improper operation.

■After completing the assembly, please

check the following.

1Insert the pedal
cord plug into the
pedal connector.
2Attach the
cord holders
to the side
panel as
shown, then
clip the cord
into the
holders.
1With the rear
panel on the
feet’s protruding
edge, align the
panel with the
groove and
secure the top
of the panel.
2Secure the left and right corners using the
4x14mm thin screws.
3Secure the top center and
bottom of the panel using the
4x20mm tapping screws.
240
127
110
220
• Are there any parts left over?
→Review the assembly procedure and correct
any errors.
• Is the Clavinova clear of doors and other
movable fixtures?
→Move the Clavinova to an appropriate
location.
• Does the Clavinova make a rattling noise when
you shake it?
→Tighten all screws.
• Are the pedal and power cords inserted securely
into the sockets?
→Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the
assembly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold instrument by the lower surface in the front of
the main unit and by the handles in the rear panel.
CAUTION
Do not hold the key cover or top portion. Improper han-
dling can result in damage to the instrument or personal
injury.
Top portion
Key cover