Yamaha CX-1, CX-2 FEATURES, SUPPLIED ACCESSORIES, FCC INFORMATION, Caution: Read this before operating your unit, 3. NOTE :, <CX-1> <CX-2, 2. IMPORTANT :

Caution: Read this before operating your unit

1To ensure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.

2Install your unit in a cool, dry, clean place – away from windows, heat sources, and too much vibration, dust, moisture or cold. Avoid sources of hum (transformers, motors). To prevent fire or electrical shock, do not expose to rain and water.

3Do not operate the unit upside-down. It may overheat, possibly causing damage.

4Never open the cabinet. If a foreign object drops into the set, contact your dealer.

5Always set the volume control to “–∞” before starting the audio source play: increase the volume gradually to an appropriate level after the play is started.

6Do not use force on switches, knobs or cords. When moving the set, first turn the unit off. Then gently disconnect the power plug and the cords connecting to other equipment. Never pull the cord itself.

7Do not attempt to clean the unit with chemical solvents; this might damage the finish. Use a clean, dry cloth.

8When not planning to use this unit for long periods of time (ie., vacation, etc.), disconnect the AC power plug from the wall outlet.

9Be sure to read the “Troubleshooting” section on common operating errors before concluding that your unit is faulty.

10Do not connect audio equipment to the AC outlets on the rear panel if that equipment requires more power than the outlets are rated to provide.

FCC INFORMATION

	1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT!	Compliance with FCC regulations does not guarantee that
	This product, when installed as indicated in the	interference will not occur in all installations. If this product
	instructions contained in this manual, meets FCC	is found to be the source of interference, which can be
	requirements. Modifications not expressly approved by	determined by turning the unit “OFF” and “ON”, please try
	Yamaha may void your authority, granted by the FCC, to	to eliminate the problem by using one of the following
	use the product.	measures:
	2. IMPORTANT : When connecting this product to	Relocate either this product or the device that is being
	accessories and/or another product use only high quality	affected by the interference.
	shielded cables. Cable/s supplied with this product	Utilize power outlets that are on different branch (circuit
	MUST be used. Follow all installation instructions.	Utilize power outlets that are on different branch (circuit
	MUST be used. Follow all installation instructions.	breaker or fuse) circuits or install AC line filter/s.
	Failure to follow instructions could void your FCC	breaker or fuse) circuits or install AC line filter/s.
	Failure to follow instructions could void your FCC
	authorization to use this product in the USA.	In the case of radio or TV interference, relocate/reorient the
	3. NOTE : This product has been tested and found to	antenna. If the antenna lead-in is 300 ohm ribbon lead,
	comply with the requirements listed in FCC Regulations,	change the lead-in to coaxial type cable.
	Part 15 for Class “B” digital devices. Compliance with	If these corrective measures do not produce satisfactory
	these requirements provides a reasonable level of	If these corrective measures do not produce satisfactory
	these requirements provides a reasonable level of	results, please contact the local retailer authorized to
	assurance that your use of this product in a residential	results, please contact the local retailer authorized to
	assurance that your use of this product in a residential	distribute this type of product. If you can not locate the
	environment will not result in harmful interference with	distribute this type of product. If you can not locate the
	environment will not result in harmful interference with	appropriate retailer, please contact Yamaha Electronics
	other electronic devices.	appropriate retailer, please contact Yamaha Electronics
	other electronic devices.	Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA
	This equipment generates/uses radio frequencies and, if	Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA
	This equipment generates/uses radio frequencies and, if	90620.
	not installed and used according to the instructions	The above statements apply ONLY to those products
	found in the users manual, may cause interference	The above statements apply ONLY to those products
	found in the users manual, may cause interference	distributed by Yamaha Corporation of America or its
	harmful to the operation of other electronic devices.	distributed by Yamaha Corporation of America or its
	harmful to the operation of other electronic devices.	subsidiaries.
		subsidiaries.

FEATURES

●Continuously Variable Loudness Control <For CX-2 only>

●PURE DIRECT Switch to Reproduce the Purest Source Sound

●SUBSONIC FILTER Switch to Cut Out Undesirable Ultra- Low-Frequency Signals

●PHONO (MM/MC) Selector Switch

●Video Signal Input/Output Capability (Including S Video Connections) <For CX-2 only>

●Remote Control Capability

●REMOTE CONTROL Connector to Make the Power of the Power Amplifier MX-1 or MX-2 Controlled by This Unit

SUPPLIED ACCESSORIES

After unpacking, check that the following parts are contained.

Remote Control Transmitter.

Batteries

Audio Connection Cord

Remote Control Cable

<CX-1><CX-2>

— +

—+