To Learn a New Function

1

Set to the “LEARN” position.

2 Press a key on this unit where a new function will be learned.

This unit

Other remote control transmitter

About 5–10 cm (2–4 in.)

3 Press and hold the key (on the other remote control transmitter) where the desired new function is.

Illuminates

*When the TRANSMIT/LEARN indicator stops illuminating, the learning is finished.

4 Repeat step 2 and 3 until all desired functions are successfully learned.

5 Set to the “USER” position.

Try operating your components.

Notes

●When you operate the desired component with this remote control transmitter, TRANSMIT/LEARN indicator will flash steadily.

●The originally preset function of a key is still available in the USER position if a new function has not been learned to the key.

●Successful learning to a key results in the erasure of previously learned functions and their replacement by the newly learned ones.

●If there is no more room in the memory area for a function to be learned, the TRANSMIT/LEARN indicator will flash two times. In this case, even if some keys are not occupied with functions from other remote control transmitters, no further learning is possible.

Memory back-up

All of the learned functions will be retained while you replace the batteries. However, if no batteries are installed for a few hours, the learned functions will be erased and will have to be learned again.

Trouble shooting guide

●If learning cannot be made successfully, or if this remote control transmitter does not function even though the learning was successful, check the following points:

*Check whether the batteries of the other remote control transmitter are weak.

Note that even though its batteries may be strong enough to operate the component it was made for, they may be too weak to transfer signals to this unit. If so, replace the batteries of the other remote control transmitter.

*Check whether the distance between the two remote control transmitters is too long or too short.

●The remote control transmitter’s batteries are too weak if the TRANSMIT/LEARN indicator does not illuminate or flash, or if the distance or range within which the remote control transmitter can be used decreases.

If either occurs, replace the batteries with new ones.

15