You can display the operation information for this unit on a video monitor. If you display the SET MENU and DSP sound field program parameter settings on a screen, it is much easier to see the available options and parameters than it is by reading this information on the front panel display.
If a video source is being reproduced, the OSD is superimposed over the image.
If a video source is not being reproduced (or the source component is set in the standby mode), you can set the OSD to turn on (blue background) or off with “14 DISPLAY SET” on the SET MENU.
English
Europe Hall A INIT.DLY…………30ms ROOM SIZE…………1.0 LIVENESS…………………5
Full Display (ex.)
P01 CONCERT HALL 1
Europe Hall A
Short Display (ex.)
You can change the amount of information the OSD shows.
Full Display .......... | This mode always shows the sound field program parameter |
| settings on the video monitor. |
Short Display ........ | This mode briefly shows the same contents as the front panel |
| display at the bottom of the screen, then disappears. |
Display Off ........... | This mode briefly shows the “DISPLAY OFF” message at the |
| bottom of the screen, then disappears. Afterwards, no changes to |
| operations appear on the screen except those of the ON |
| SCREEN. |
Notes:
•When you choose the Full Display mode, the INPUT selector, VOLUME, and some other types of operation information are displayed at the bottom of the screen in the same format as the front panel display.
•The OSD signal is not output through the REC OUT selector, and will not be recorded with any video signal.
•The SET MENU, TEST DOLBY SUR and TEST DSP appear regardless of the OSD mode.
ON SCREEN
1When you turn on the power, the video monitor and front panel display shows the level of the main volume for a few seconds and then switches to show the current sound field program.
2Press ON SCREEN on the remote control repeatedly to change the display mode.
The OSD mode changes in the following order: Full Display, Short Display, and Display Off.
Notes:
•If you choose a video input source that has component connected to both the S VIDEO IN and composite VIDEO IN jacks, and both the S VIDEO OUT and composite VIDEO OUT jacks are connected to a video monitor, the video signal is output to both the S VIDEO OUT and VIDEO OUT jacks. However, the OSD is carried only on the
•If your video monitor is connected only to the COMPONENT VIDEO jacks of this unit, the OSD is not shown. Make sure to connect your video monitor to the COMPONENT VIDEO jack and either VIDEO or S VIDEO jacks if you would like to see the OSD.
•Playing back video software that has an
19