Yamaha EMX-220VCD Manual tuning, TUNING OPERATION, Automatic tuning, press the button to tune to a lower frequency, 3 Press and hold the button to tune to a higher

TUNING OPERATION

1 2

VIDEO CD CHANGER RECEIVER								A/B/C/D/E	PRESET/TUNING/BAND
		VIDEO CD				OPEN/CLOSE	DISC
							CHANGE
						DISC 1	DISC 2	DISC 3
PROGRAM						INPUT SELECTOR		VOLUME
						VCD/CD	TUNER
STANDBY/ON
ECHO	MUSIC	ECHO
						VCR•LD/TV•VCD/CD•TAPE/MD•TUNER
KARAOKE		MEMORY
PHONES						MIC TONE		MIC	MIC MIXING
		DISPLAY	MEMORY AUTO/MAN’L	REPEAT	TIME	INPUT TRIM

3, 2 4, 3

	VCD/CD		TUNER
1	2	3	4	5
1	2	3	4	5
6	7	8		PRESET
6	7	8	9	0
A	B	C	D	E
TIME	PROG			+I0
MODE	INDEX		RANDOM OPEN/CLOSE

1	DISC SKIP	PREV	NEXT	RETURN	SELECT
	VCD/CD	TUNER		STOP	PLAY/PAUSE
	CENTER/REAR			INPUT
		TEST	MUSIC	TIME INDEX
	/DELAY
	ECHO/KEY		PROGRAM	INTRO	DIGEST
	LEVEL
	SLEEP	STANDBY/ON			KARAOKE

VOLUME

Normally, if station signals are strong and there is no interference, quick automatic-search tuning (Automatic tuning) is possible. However, if signals of the station you want to select are weak, you must tune to it manually (Manual tuning).

Automatic tuning

1 Select the tuner by pressing the TUNER INPUT SELECTOR button so that “TUNER” appears on the display.

2 Select the reception band (FM or AM) by pressing the PRESET/TUNING/BAND button confirming it on the display.

*Do not select a preset tuning mode (in which “PRESET” lights up on the display.)

3 Press the AUTO/MAN’L button so that “AUTO” lights up on the display.(In this mode, stations are received in stereo or monaural automatically.)4 Press the button to tune to a higher frequency, orpress the button to tune to a lower frequency.(When tuned in to a station, “TUNED” will light up on the display.)

5 If the station where tuning search stopped is not the desired one, follow step 4 again.

*If the tuning search does not stop at the desired station, change to the Manual tuning method as described below.

*STEREO indicator will light up when an FM stereo broadcast with sufficient signal strength is received.

Manual tuning1 Follow steps 1 and 2 of the Automatic tuning method.2 Press the AUTO/MAN’L button so that “AUTO” disappears from the display.(In this mode, stations are received in monaural.)3 Press and hold the button to tune to a higherfrequency, or press and hold the button to tune to a lower frequency.

Release it just before reaching the desired frequency, and then press it repeatedly until the desired frequency appears.

(When tuned in to a station, “TUNED” will light up on the display.)

Note

If you tune in to an FM station manually, it is received in monaural automatically to increase the signal quality.

Note

Pressing the TUNER input selector button on the remote control transmitter switches the tuner from FM to AM mode and vice versa.

E-30