28 EMX5016CF Owner’s Manual
Front & Rear Panels
Reference
Rear Panel
mSPEAKERS jacks
Use these jacks to connect to speakers. Note that the
output directed to these jacks varies according to the
setting of the POWER AMP switch a.
A1, B1: NEUTRIK NL4 Speakon outputs. Polarities
are as shown below.
A2, B2: Phone output jacks.
nPOWER Switch
This switch turns the EMX power ON and OFF.
Before turning the power ON or OFF, be sure to turn
both the ST master fader and the AUX1 and AUX2
faders are all the way down.
oAC IN Connector
Connect the included power cable here. Connect one
end of the cord to this connector, and then plug the
other end into a standard power outlet.
Before turning the power ON or OFF, be sure to turn
both the ST master fader and the AUX1 and AUX2
faders are all the way down.
pGround Screw
For maximum safety be sure to securely connect the
EMX to an earth connection. The supplied power cable
has a three-prong plug that will ground the unit when
the plug is inserted into an appropriately grounded
three-prong type AC mains outlet. If the AC outlet is
not grounded, be sure to ground the unit by using this
ground screw. Correct grounding will effectively elim-
inate hum noise and interference.

o

p

n

m

Neutrik Plug A1 and B1 Connectors
1+
1–
2+
2–
2+ 2-
1- 1+
+
–
CAUTION
CAUTION