Yamaha EMX5016CF Master Section

Front & Rear Panels

EMX5016CF Owner’s Manual 23

Reference

Master Section OST SUB OUT Jacks

These unbalanced phone jacks output the mixed stereo

signal (L and R), where the level is adjusted by the ST

SUB OUT control g. You would typically use these

jacks to connect to an external mixer or a supplemen-

tary SR system.

PREC OUT Jacks

These RCA pin-type unbalanced output jacks can be

used to send the main stereo signal to an external DAT

recorder or cassette recorder. The jacks output the ste-

reo signal pre adjustment by the ST master fader l

and graphic equalizer W. As the signal is not adjusted

by these controls, please be sure to make appropriate

level adjustments at the external recording device side.

QEFF1/2 ON/OFF Jacks

These phone input jacks are for connection to a sepa-

rately sold FC5 foot switch. The foot switch can be

used as an alternative to the ON switch to toggle the

effector on and off.

RST OUT Jacks

These unbalanced phone jacks output the mixed stereo

signal (L and R), where the level is adjusted by the ST

master fader l. You would typically connect these

jacks to a power amp or powered speakers.

SPHONES Jack

Connector for headphones. This is a balanced stereo

phone-type output jack.

TLAMP Jack

This XLR 3 pin-type output jack is for connection to

an optional lamp.

Supported lamps: 12 V (AC or DC), max. 5 W. Power

of 12 V is supplied between pins 2 and 3. Pin 1 is not

connected.

UGEQ (Graphic Equalizer) display

Indicates the GEQ settings. This 9-band GEQ adjusts

the frequency characteristics of the stereo-bus signal

output at the ST OUT jacks R, ST SUB OUT jacks

O, and SPEAKERS jacks m.

VGEQ +/– Switches

These switches boost or cut the gain of each frequency

band by ±12 dB. The central frequencies for the bands

are: 63, 125, 250, 500, 1k, 2k, 4k, 8k and 16k Hz. The

adjustable gain values are: 0dB, ±1.5dB, ±3dB,

±4.5dB, ±6dB, ±9dB and ±12dB. For intermediate val-

ues not printed on the scale, both the upper and lower

indicators light. (For example, the 0 and +3 indicators

light to indicate a value of +1.5dB.)

WGEQ ON Switch

This switch toggles the graphic equalizer on or off.

The switch is illuminated when on.

NOTE