Yamaha EX5, EX5R, EX7

Performance Mode

161

■Arp Sw (Arpeggio Switch)

Turns the Arpeggiator on and off.

❏ Settings: off, on

The ARPEGGIO key on the front panel also serves the

same function. However, to actually activate the

function, in the LYR (Layer) screen of each part, set the

Layer Sw (Layer Switch) and the Arpeggio Switch to

“on” (see page 166).

■Arp Type (Arpeggio Type)

Sets the arpeggio type.

❏ Settings: See the Arpeggio Type List in the separate Data

List book.

■Arp Tempo (Arpeggio Tempo)

Sets the arpeggio tempo.

❏ Settings: 30~250

■Tempo Ctrl (Tempo Control)

Sets whether one of the Knobs controls the arpeggio

tempo, or not.

❏ Settings: off, knob 1~6

■Arp Hold (Arpeggio Hold)

Sets the Arpeggio Hold to “on” or “off.” When

Arpeggio Hold is set to “on,” even if you remove

your fingers from the keyboard after playing, the

arpeggio will continue to loop indefinitely.

❏ Settings: on, off

■Arp Note LimitL (Note Limit Low)

Sets the lowest note of the arpeggio range on the

keyboard.

❏ Settings: C–2~G8

The lowest note you set here and the note set for the

Arp Note High (Note Limit High) shown below,

determine the range of notes within which the

arpeggios will play.

■Arp Note LimitH (Note Limit High)

Sets the highest note of the arpeggio range on the

keyboard.

❏ Settings: C–2~G8

■Arp MIDI Ch (Arpeggio MIDI Channel)

Sets the MIDI channel for the Arpeggiator. The

voice of the part assigned to the same MIDI channel

is arpeggiated.

❏ Settings: 1~16

■Arp MIDI A/B (Arpeggio MIDI OUT A/B)

Sets the phrase of the Arpeggiator MIDI note to

output from each MIDI OUT A/B when set to “on.”

When set to “off,” no notes are output.

❏ Settings: on, off

Arpeggio MIDI Out A/B is available for EX5. In the

case of EX5R and EX7, only a set of Arp MIDI Out is

available.

[F6]: EFCT (Effects)

These are parameter settings related to the System

Effects (effects equally applied to the entire parts).

When the EFCT menu is selected using [F6], the

following menu will be displayed.

[F6]: TYPE

[F7]: REV (Reverb)

[F8]: CHO (Chorus)

The Insertion Effects (effects applied to each part) is not

set here, but in Voice Edit mode (page 105).

For more information about effects, see page 65.

[F6]: TYPE

Sets the type of Reverb and Chorus effects. You can set

the send and return levels of each effect unit to

complete the total amount of effect signal for all parts.

■1Rev Type (Reverb Type)

Selects the type of reverb for the Reverb unit.

❏ Settings: 00 (off)~12

For more information about each type of reverb, see the

Effect Type List in the separate Data List book.

267

F6 F7 F8

Performance/E/qx 5/21/98 11:35 AM Page 161