Precautions: Read this before operating your system
This system is not disconnected from the AC power source as long as it is connected to the wall outlet, even if this system itself is turned off. This state is called the standby mode.
In this state, this system is designed to consume a certain level of power.
Note
Please check the copyright laws in your country to record from records, compact discs, radio, etc. Recording of copyright material may infringe copyright laws.
CAUTION FOR CARRYING THE MAIN UNIT
Be sure not to carry or tip the main unit with discs remaining in it.
CAUTION FOR MOVING THE MAIN UNIT
Before moving the main unit, first remove all discs from the disc tray and close the tray by pressing the OPEN/CLOSE button. After you confirm that “NO DISC” lights up on the display, turn this system into the standby mode by pressing the STANDBY/ON switch, and then disconnect the power plug from the AC outlet.
Voltage Selector (China and General models only) The voltage selector on the rear panel of the main unit must be set for your local main voltage BEFORE plugging into the AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
FREQUENCY STEP switch (China and General models only)
Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (located at the rear) according to the frequency spacing in your area.
Be sure to change the setting of this switch with the AC supply lead of this system disconnected from the AC outlet.
WARNING
To reduce the risk of fire or electric shock, do not expose this system to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
As the laser beam used in this unit is harmful to the eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only.
This system is classified as a
CLASS 1 LASER product.
CLASS 1 LASER PRODUCTThe CLASS 1 LASER
PRODUCT label is located on the rear exterior.
Laser component in this product is capable of emitting radiation exceeding the limit for Class 1.
The CD/Video CD player in this system can play discs of the following types only.
Type of disc |
| Mark printed | Type of signal | Size (Dimension) | Maximum possible | ||||
| on the disc | recorded | play time | ||||||
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
Video CD |
|
|
|
|
|
| Sound | 12 cm | 74 minutes |
|
|
|
|
|
| + |
|
| |
|
|
|
|
|
| 8 cm (Single type) | 20 minutes | ||
|
|
|
|
|
|
| Picture (Movie) | ||
|
|
|
|
|
|
|
|
|
|
CD |
|
|
|
|
|
| Sound only | 12 cm | 74 minutes |
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| 8 cm (Single type) | 20 minutes | ||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
Never attempt to play a disc other than above with the CD/Video CD player because it may cause a damage to this system.
VIDEO CD
Video CDs are classified into two types, version 1.1 and 2.0. The CD/Video CD player can play both types.
Video CD (version 1.1): With the same operation as compact discs, you can enjoy sounds and pictures (movies).
Video CD (version 2.0): In addition to a normal play which is the same as version 1.1, you can enjoy a Playback Control operation. (For details on Playback Control, refer to page 16.)