Yamaha H01 2. , 3. , 4. , 5.

Keyboard Stand Assembly
H01 Owner’s Manual
ENGLISH
23
2. Raise A to the vertical position.
2-1Raise A to the vertical position, with the keyboard
side on the bottom, and hold A securely.
CAUTION
Do not tip A further than 90 degrees to avoid stress to the
key cover and lid.
3. Attach B.
3-1Align the holes on A with those on B and hold A
and B together.
3-2Finger-tighten six short screws (6x20 mm) start-
ing with the top hole.
3-3Tighten the screws securely.
4. Attach C.
4-1Hold C so that the notch on the bracket will face
toward left, then align the holes on A with those
on C.
4-2Finger-tighten four short screws (6x20 mm) start-
ing with the top hole.
4-3Tighten the screws securely.
5. Assemble the pedal structure.
5-1Pass the pedal cord (that comes out from the rear
of pedal box E) through a hole on the bracket of
D, then pass it through the pipe.
5-2Align the holes on the bottom of E with the holes
on the bracket of D, then attach E and D by tight-
ening six small screws (4x6 mm). At this time,
first tighten the two center screws, then tighten
the rest of the screws.
5-3Pull the end of the pedal cord to eliminate any
slack inside the bracket on D.
CAUTION
Hold E securely to avoid slippage.
AA
CAUTION
Do not release A until you
finish Step 4.
A
B
A
B
A
CC
E
D
E
DD
E
21