›PHONES jack

To listen with headphones, connect the headphones to the PHONES jack. The sound output from the PHONES jack is the same as that from the main speakers.

When listening with headphones privately, set both the SPEAKERS A and B switches to the OFF position and switch off the digital sound field processor (so that no DSP program indicator is lit in the display) by pressing the EFFECT button.

PHONES

%SPEAKERS switches

Set the switch A or B (or both A and B) for the main speaker system (connected to this unit) you will use to the ON position. Set the switch for the main speaker system you will not use to the OFF position. (Refer to page 25.)

fiA/B/C/D/E button

Press this button to select a desired group (A–E) of preset stations. (Refer to page 27.)

^Preset station number selector buttons

Press to select a preset station number (1 to 8). (Refer to page 27.)

flTone controls

These controls are effective only for the sound from the main speakers. (Refer to page 25.)

BASS

Used to increase or decrease the low frequency response. The 0 position produces flat response.

TREBLE

Used to increase or decrease the high frequency response. The 0 position produces flat response.

&BALANCE control

This control is effective only for the sound from the main speakers.

Adjusts the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions. (Refer to page 25.)

‡RDS MODE/FREQ button HTR-5130RDS only When an RDS station is received, pressing this button repeatedly changes the display to the PS mode, PTY mode, RT mode, CT mode (RDS services subject to availability), and station frequency in turn. (Refer to page 32.)

*PTY SEEK MODE button HTR-5130RDS only

When this button is pressed, the unit turns into the PTY SEEK mode. (Refer to page 33.)

°PTY SEEK START button HTR-5130RDS only Press this button to begin searching for a station after the desired program type is selected in the PTY SEEK mode. (Refer to page 33.)

(EON button HTR-5130RDS only

Press this button to select a specified program type (NEWS, INFO, AFFAIRS, SPORT) when you want to locate a radio program of that type automatically. (Refer to page 34.)

·TUNING DOWN/UP button

Use for tuning radio stations. Press the UP side to tune in to higher frequencies, and press the DOWN side to tune in to lower frequencies.

HTR-5130RDS only When this unit is in the PTY SEEK mode, press either side of this button to change the currently selected program type.

)DSP program selector buttons

Select a DSP program. When a button is pressed, the name of selected program lights up on the display. (Refer to page 35.)

‚EFFECT button

Switches the digital sound field processor on and off (including the Dolby Pro Logic Surround decoder). (Refer to page 36.)

_CENTER MODE button

Selects a center channel output mode (NORMAL, WIDE or PHANTOM). (Refer to page 20.)

—DELAY/CENTER/REAR/SWFR and TIME/LEVEL +/–

buttons

Adjust the delay time (DELAY), the center channel output level (CENTER), the rear channel output level (REAR) and the output level to the SUBWOOFER OUTPUT terminal (SWFR). Select the item which you want to adjust by pressing the DELAY/CENTER/REAR/SWFR button and adjust its time or level by pressing the TIME/LEVEL +/–button. (Refer to pages 25, 37, and 38.)

English

15