TUNING OPERATIONS

Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).

L R

1 3 2 4

AUTOMATIC TUNING

1 Select “TUNER” as the input source.

TAPE/MD

TUNER PHONO CD MONITOR

2 Select the reception band (FM or AM) confirming it in the display.

FM/AM

or

3 TUNING MODE

AUTO/

AUTO

4 To tune to a higher frequency, press the right side once. To tune to a lower frequency, press the left side once.

DOWN TUNING UP

*If the station where tuning search stops is not the desired one, press again.

*If the tuning search does not stop at the desired station (because the signals of the station are weak), change to the MANUAL TUNING method.

26

MANUAL TUNING

1 Select “TUNER” as the input source.

TAPE/MD

TUNER PHONO CD MONITOR

2 Select the reception band (FM or AM) confirming it in the display.

FM/AM

or

3

TUNING

MODE

AUTO/

Turn the “AUTO”

 

indicator off.

4 Tune to a desired station manually.

DOWN TUNING UP

*For a continuous tuning search, press and hold the button.

Notes

●If you tune to an FM station manually, it is received in monaural mode automatically to increase the signal quality.

●HTR-5130RDS only When tuned to a station, the frequency of the received station is shown on the display. If an RDS station that employs PS data service is received, the frequency is then replaced by the station name. Refer to page 32 for details.