TROUBLESHOOTING
Problem | Cause | Remedy | Refer to | |
page | ||||
|
|
| ||
|
|
|
| |
Dolby Digital or DTS | The connected component is not set to | Make an appropriate setting following the operating | — | |
sources cannot be | output Dolby Digital or DTS digital | instructions for your component. |
| |
played. (Dolby Digital | signals. |
|
| |
or DTS indicator in |
|
|
| |
The input mode is set to ANALOG. | Set the input mode to AUTO or DTS. | |||
the front panel | ||||
display does not light |
|
|
| |
up.) |
|
|
| |
|
|
|
| |
A “humming” sound | Incorrect cable connections. | Firmly connect the audio plugs. If the problem | — | |
can be heard. |
| persists, the cables may be defective. |
| |
|
|
|
| |
The volume level | The component connected to the OUT | Turn on the component. | — | |
cannot be increased, | jacks of this unit is turned off. |
|
| |
or the sound is |
|
|
| |
distorted. |
|
|
| |
|
|
|
| |
The sound effect | It is not possible to record the sound effect |
|
| |
cannot be recorded. | with a recording component. |
|
| |
|
|
|
| |
A source cannot be | The source component is not connected to | Connect the source component to the analog IN jacks. | ||
recorded by an | the analog IN jacks of this unit. |
|
| |
analog component |
|
|
| |
connected to the OUT |
|
|
| |
jacks. |
|
|
| |
|
|
|
| |
This unit does not | The internal microcomputer has been | Disconnect the AC power cable from the outlet and | — | |
operate properly. | frozen by an external electric shock (such | then plug it in again after about 30 seconds. |
| |
| as lightning or excessive static electricity) |
|
| |
| or by a power supply with low voltage. |
|
| |
|
|
|
| |
There is noise | This unit is too close to the digital or high- | Move this unit further away from such equipment. | — | |
interference from | frequency equipment. |
|
| |
digital or radio |
|
|
| |
frequency equipment, |
|
|
| |
or this unit. |
|
|
| |
|
|
|
| |
The picture is | The video source uses scrambled or |
|
| |
disturbed. | encoded signals to prevent dubbing. |
|
| |
|
|
|
| |
This unit suddenly | The internal temperature becomes too | Wait about 1 hour for this unit to cool down and then | — | |
turns into the standby | high and the overheat protection circuitry | turn it back on. |
| |
mode. | has been activated. |
|
|
INFORMATION | ADDITIONAL |
|
|
English
35