Yamaha KX-10 PLAYBACK, Preparation for playback, DOLBY NR button setting (in step 2), To fast forward the tape, To fast rewind the tape, To adjust the volume level

PLAYBACK

Preparation for playback

¶Press the STANDBY/ON switch to turn on the power.

¶Set your amplifier to cassette deck function mode.

	1	! ⁄			B/	C indicators
			SOURCE	REC I/NORM II/HIGH IV/METAL
			TAPE	TAPE TUNING	ŸB C	MPX FILTER
		L		Ÿ 0
		dB 30 20 15 10	8 6 4		2 4	6
		R
STANDBY/ON
switch
2	COUNTER	MONITOR	7STOP PLAY TRIM 3
	RESET
1	2					3
)		DOLBY NR				‹ PLAY

OFF/ŸB/

ŸC/MPX

Place the cassette on the cassette tray with the exposed tape	Refer to “DOLBY NR button
side facing back side of the unit and the side to be played facing
up. To load the cassette tray, press the )button.	setting”.

¶Make sure that the tape is wound to the right-hand reel with the cassette placed on the tray.

ENGLISH

DOLBY NR button setting (in step 2)

Be sure to set the DOLBY NR button according to the system used for recording. Each time this button is pressed, Dolby NR switches as follows:

To fast forward the tape

Press the ⁄ button.

To fast rewind the tape

Press the ! button.

3B (MPX off)

3

C (MPX off)

3 B MPX on

3 C MPX on

For a tape recorded with DOLBY B NR Only the B indicator lights.

For a tape recorded with DOLBY C NR Only the C indicator lights.

(available only for recording)

(available only for recording)

To adjust the volume level

Use the volume control of the amplifier.

To stop playback and remove the cassette tape

Press the 7 STOP button and then the ) button. The cassette tray comes out and you can remove the cassette tape.

3	For a tape recorded with DOLBY NR OFF
OFF
	No indicator lights.

Note:

The MPX filter settings are explained on page 8.

*Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation.

“DOLBY” and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation.

To enter the standby mode

Press the STANDBY/ON switch again.

5