DOLBY NR selector setting (in step 2)
Set the DOLBY NR selector according to your purpose. OFF: No noise reduction.
B: For recording the sources with Dolby B NR. 
C: For recording the sources with Dolby C NR.
ÖDolby noise reduction is an extremely effective method of reducing undesirable background hiss on tapes. This unit incorporates both Dolby B NR and the newer Dolby C NR system. Dolby C NR is approximately twice as effective as the earlier Dolby B NR.
REVERSE MODE selector setting (in step 3)
The auto reverse function allows the tape running direction to be reversed automatically. Select the auto reverse mode
(
) or manual reverse mode ( 
).
: When recording on one side of a tape is finished, the deck stops at the end of the tape.
:Both sides of a tape are recorded. After recording, the deck stops at the end of the tape.
ÖWhen the tape running direction is set to ª, only the reverse side is recorded.
ÖIf you select 
or 
RELAY , the reverse mode
automatically switches to 
in step 5.
Setting the recording level (in step 6)
Play the loudest passage of the source to be recorded and watch the meter readings.
Adjust the REC LEVEL control so that the highest peak reaches +4 of the optimum recording level. Normally, it is best to adjust the REC BALANCE control
ENGLISH
Display during recording
The A or B indicator shown in the display represents the last deck operated.
Tape counter
Use the tape counter to aid in locating a point on a tape (0000 to 9999).
To set the counter reading to “0000”, press the RESET button.
MODE indicator
Tape running direction indicator
DOLBY B/ C indicator
REC indicator
|
| ÛA Ü |
| RELAY | ÛB Ü |
|
|
|
| |
|
|
|
|
| B C REC |
|
|
|
| |
L |
|
|
|
|
|
|
|
|
| + |
15 | 10 8 | 6 | 4 | 2 | 0 | 2 | 4 | 6 | ||
R |
|
|
|
|
|
|
|
|
|
|
Peak level meters
Indicate the peaks of the signal levels during recording and playback over a
To stop recording: | To stop recording temporarily: |
Press the & button. | Press the REC/PAUSE button. To resume recording, press |
| the PLAY button. |
11
