Using the KX with Cubase
Owner’s Manual 21
Holding Arpeggio playback
4.
Press the [HOLD] button (the lamp lights).
5.
Press a single note on the keyboard.
The Arpeggio (rhythm pattern) starts just by
playing a single note. While the [HOLD] lamp is
turned on, Arpeggio playback will not stop
even if you release the note meaning that you
can perform another operation during
playback.
6.
Press the [HOLD] button again (the lamp
goes out). To stop Arpeggio playback.
Trying out other notes on the keyboard
7.
Press the lowest C (leftmost note).
A rhythm pattern starts playing.
8.
Next, press the G located a fifth above the C
pressed in step 7.
A different rhythm pattern starts.
9.
Next, press the C located a fourth above the
G pressed in step 8.
A rhythm pattern different from the previous two
patterns starts.
10.
Next, press the G located a fifth above the C
pressed in step 9.
A rhythm pattern different from the previous
three patterns starts.
11.
Finally, press the C located a fourth above
the G pressed in step 10 (the highest C of
the KX25).
The rhythm pattern same as that played in step
7 starts.
NOTE
By pressing a footswitch connected to the
SUSTAIN jack (page 16), the Arpeggio
continues to play, even if you release the
note. In this case, you can stop Arpeggio
playback by releasing the footswitch.
On
Off
NOTE
If you are using the KX8, press the lowest C
key on the keyboard (the C a third above the
lowest key).