Yamaha MG 6FX, MG16

Front & Rear Panels

MG16/6FX

C-R OUT Jacks

These are impedance-balanced phone-type output jacks. These

jacks output the mixed signal whose level is adjusted by the

C-R/PHONES control. Output is in stereo (L and R). These

jacks are typically used to connect to a monitor system.

The signal monitored by these jacks is selected by

the Level-Meter Signal switches and the channel

PFL switches.

SEND Jacks

•AUX1, AUX2

These are impedance-balanced phone-type output jacks.

These jacks output the signal from AUX1 and AUX2, respec-

tively. You use these jacks, for example, to connect to an

effector or to a cue box or other such monitoring system.

•EFFECT

This is an impedance-balanced phone-type output jack that

outputs the signal from the EFFECT bus. You use this jack,

for example, to connect to an external effector.

RETURN L (MONO), R Jacks

These are unbalanced phone-type input jacks. The signal

received by these jacks is sent to the Stereo bus and the AUX1

and AUX2 buses. These jacks are typically used to receive a

return signal from an external effector (reverb, delay, etc.).

These jacks can also be used as an auxiliary stereo

input. If you connect to the L(MONO) jack only, the

mixer will recognize the signal as monaural and will

propagate the identical signal on both L and R

jacks.

REC OUT (L, R) Jacks

These are unbalanced RCA-pin-type output jacks. By connect-

ing these jacks to an external recorder, you can record the same

signal that is being output from the ST OUT jacks.

The mixer’s ST Master Fader does not operate on

the signal output from these jacks. Be sure to make

appropriate level adjustments at the external

recording device.

2TR IN Jacks

These unbalanced RCA-pin-type input jacks are used to input a

stereo sound source. Use these jacks when you want to connect

a stereo sound sources (CD or DAT) directly to the mixer for

monitoring.

You can adjust the signal level using the 2TR IN

control in the Master Control section.

POWER Switch

Use this switch to set the mixer power to ON or STANDBY.

Note that trace current continues to ﬂow while the

switch is in the STANDBY position. If you do not plan

to use the mixer again for a long while, be sure to

unplug the adaptor from the wall outlet.

AC ADAPTOR IN Connector

Connects to the included PA-30 power adaptor (see page 5).

Use only the PA-30 adaptor included with this mixer.

Use of a different adaptor may result in ﬁre or electric

shock.

Connector Polarities

* These jacks will also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced.

NOTE

MIC INPUT, ST OUT

Pin 1: Ground

Pin 2: Hot (+)

Pin 3: Cold (–)

LINE INPUT (monaural channels),

GROUP OUT, ST OUT, C-R OUT,

AUX1, AUX2, EFFECT*

Tip: Hot (+)

Ring: Cold (–)

Sleeve: Ground

INSERT I/O

Tip: Output

Ring: Input

Sleeve: Ground

PHONES

Tip: L

Ring: R

Sleeve: Ground

RETURN,

LINE INPUT (stereo channels)

Tip: Hot

Sleeve: Ground

INPUT OUTPUT

Ring

Sleeve Tip

MG16-6FX.fm Page 24 Wednesday, January 29, 2003 6:04 PM