101
MIDI Data Format

2.2.1.3 Multi Effect1 bulk dump

This message sets the MULTI EFFECT1 block (refer to tables
<1 - 1>, <1 - 4>).

2.2.1.4 Multi Part bulk dump

This message sets the MULTI PART block (refer to tables
<1 - 1>, <1 - 6>).

2.2.1.5 Drums Setup bulk dump

This message sets the DRUMS SETUP block (refer to tables
<1 - 1>, <1 - 7>).

2.3 Parameter request

This message requests transmission of a parameter value.
The output is transmitted in the Parameter Change message
format (refer to 2.1.3).

2.3.1 XG parameter request

This message requests transmission of XG parameter settings.
Settings are transmitted in the format of an XG parameter
change (refer to 2.1.3).
11110000 F0H Exclusive status
01000011 43H YAMAHA ID
0011nnnn 3NH N:device Number
01001100 4CH Model ID
0ggggggg GGH Address High
0mmmmmmm MMH Address Mid
0lllllll LLH Address Low
11110111 F7H End of Exclusive

2.4 Dump request

This message requests transmission of a specific block of
parameter values.
The output is the same as the bulk dump format.

2.4.1 XG dump request

This message requests transmission of all parameters of the
specified block of XG parameters.
The output is the same as the format of XG bulk dump (refer to
2.2.1).
11110000 F0H Exclusive status
01000011 43H YAMAHA ID
0010nnnn 2NH N:device Number
01001100 4CH Model ID
0ggggggg GGH Address High
0mmmmmmm MMH Address Mid
0lllllll LLH Address Low
11110111 F7H End of Exclusive
Address is valid only when the beginning of the block has been
specified.
3. Realtime messages

3.1 Active sensing

This message is used to prevent problems which could occur if
a MIDI cable were to be disconnected or broken
during a performance.When this message is received, the
MU100R will begin monitoring the state of the MIDI cable.
a) Transmission
not transmitted.
b) Receive
Once FE has been received, failure to receive any
MIDI message for an interval longer than approxi-
mately 300 msec will cause processing to be
performed as if ALL SOUND OFF, ALL NOTE OFF,
and RESET ALL CONTROLLERS messages were
received, and the unit will reset to a condition in which
FE was never received.