Editing VL Voice Part Parameters
24
6Breath Noise
Bnz CC No. (Breath Noise Control Change Number) ....... Settings: off … 95, AT, VEL, PB
“Breath Noise” can be used to add the required amount of breath noise to a voice. The “Bnz CC
No.” parameter specifies the controller to be used for breath noise control. When set to “off” no
breath noise variation can be produced via a controller, but a continuous breath noise value is
determined by the “BnzCtrlDpt” parameter, below (negative values increase the breath noise
level).
BnzCtrlDpt (Breath Noise Control Depth) ............................................. Settings: -64 … +63
Sets the amount of variation produced by the controller assigned to breath noise. The higher the
value the greater the variation. Positive values cause an increase in breath noise in response to
higher controller values (e.g. increased breath pressure or higher modulation wheel position),
while minus values cause a decrease in breath noise in response to higher controller values.
7Growl
Grl CC No. (Growl Control Change Number) ................... Settings: off … 95, AT, VEL, PB
“Growl” produces a periodic pressure modulation which produces the “growl” effect often heard
in wind instruments. The “Grl CC No.” parameter specifies the controller to be used for growl
control. When set to “off” no growl variation can be produced via a controller, but a continuous
growl value is determined by the “GrlCtrlDpt” parameter, below (negative values increase the
growl level).