PM1D Manager V2 for Windows Owner’s Manual
22
USB MIDI Driver

If you are connecting the console/engine to a USB port on your PC, you’ll need to install the Yamaha USB

driver. If this driver is already installed, or if you will be using a serial connection (RS-232-C connector), you

do not need to install the USB driver.

The procedure for installing the Yamaha USB driver
depends on the version of Windows that you are using.

Windows 2000

1. Start your PC and Windows, log on as the Adminis-
trator, and then insert the included CD-ROM into
your PC’s CD-ROM drive.
2. Go to My Computer→Control Panel→
System→Hardware→Driver Signing→File Signa-
ture Verification, select “Ignore-Install all files,
regardless of file signature,” and then click OK.
3. Power-off the console/engine, and use a USB cable
to connect the console/engine to the PC.
The USB connector of the console/engine is located
in the PC CONTROL section of the rear panel.
4. Turn on the console/engine.
The Found New Hardware Wizard appears.
5. Click Next.
6. Select “Search for a suitable driver for my device
(Recommended),” and then click Next.
7. In the subsequent window, select “CD-ROM
drives” only, and then click Next.
You may be prompted to insert your Windows CD-ROM.
Do not insert it! Click OK, and in the “Copy files from” sec-
tion of the subsequent dialog box, enter “D:\USBdrv2k_”
(replacing “D” with the drive letter of your CD-ROM
drive), and then click OK.
The driver is installed, and the message “Completing
the Found New Hardware Wizard” appears.
8. Click Finish, and then restart your PC.

Windows XP

1. Power-on the PC, and when Windows starts up, log
in using an account with Administrator privileges.
2. Insert the included CD-ROM into your PC’s CD-
ROM drive.
3. Click the Start button, and then click Control
Panel.
If the Control Panel window appears as shown
below, click “Switch to Classic View” on the left side
of the window in order to see all the control panels.
4. Go to System Hardware→Driver signatures→
Driver signature options, select “Ignore-Install
software without asking for confirmation,” and
then click OK.
5. Click OK to close the System Properties window,
and then click the Close button to close the Control
Panel window.
6. Power-off the console/engine, and use a USB cable
to connect the console/engine to the PC.
The USB connector of the console/engine is located
in the PC CONTROL section of the rear panel.
7. Turn on the console/engine.
The Found New Hardware Wizard appears.
8. Select “Install software automatically (recom-
mended) (I),” and then click Next.
The driver is installed, and the message “Completing
the Found New Hardware Wizard” appears.
9. Click Finish, and then restart your PC.
PC
Driver
PM1D
Manager
Console/engine
(CS1D/DSP1D)
USB cable