Yamaha Portatone Entertainment Station, PSR-K1 Inserting the SmartMedia card, Setting up the included microphone

Setting Up

Inserting the SmartMedia card

BEFORE you turn on the power of this instrument, make sure to properly insert the included SmartMe- dia card in the card slot on the rear panel.

With the gold-plated contact side facing down, insert the SmartMedia card firmly but carefully into the card slot, as far as it will go. Be careful not to insert the card upside down or back side in.

* This instrument uses SmartMedia™ (3.3V) memory cards.

Setting up the included microphone

Also included with the instrument is a microphone, letting you enjoy karaoke sing-alongs while playing back the songs, or for singing and playing at the same time.

■Connecting the microphone

Before turning on the power of this instrument, connect the plug of the included microphone to the MIC jack on the rear panel.

MIC

ROUTPUT
L	PHONES
	DC	IN	12V
	+
			-

By inserting the SmartMedia card beforehand, you have access to the SmartMedia card songs, as well as your custom backup settings, including those of the panel controls, Registration Memory, and User songs. (See page 52, 84.)

•Use your SmartMedia card! If you use the instrument without it, all settings and recordings you make—User songs, panel settings, and Registration Memory—are all lost when you turn off the power.

•Be careful not to insert or pull out the SmartMedia card while the power is turned on. Doing so may result in damage to the SmartMedia card and the internal data. Make sure to insert and pull out the SmartMedia card only when the power is off.

Make sure to read the section “Using SmartMe- dia™ cards (memory cards)” on page 11 for more important information on the SmartMedia card.

NOTE

•To avoid loud pops and sudden noise, turn the volume of the micro- phone all the way down by turning the [MIC VOLUME] control to the left. Also, set the microphone switch to OFF.

ON

OFF

DYNAMIC

•Use the cable holder next to the MIC jack to securely fasten the cable and prevent the plug from being inadvertently pulled out.

Cable holder

MIC

OU	TPUT
R
	L	PHONES
		DC	IN	12V
		+
				-

■Moving the Microphone Holder

The microphone holder can be installed on either side of the instrument. If you remove the holder, put the spare microphone holder cap in the hole.

12 PSR-K1 Owner’s Manual

Microphone holder

Microphone holder cap