Yamaha RX-396, RX-496 PRESET TUNING

PRESET TUNING

MANUAL PRESET TUNING

This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station only by selecting the preset station number where it is stored. Up to 40 stations (8 stations x 5 groups) can be stored.

NATURAL SOUND STEREO RECEIVER

																										VOLUME
																									20	l6
																				TUNER			PHONO	CD		l2
																									28	8
STANDBY/ON
																									40	4
																				AUX			TAPE 2	TAPE 1/MD	60	2
		A/B/C/D/E	1			2			3			4		5	6		7	8					MONITOR			0
																										–dB
PHONES	SPEAKERS		BASS					TREBLE				BALANCE			LOUDNESS				FM/AM		DOWN TUNING UP
			l	0	l			l	0	l		l	0	l	l	FLAT	–30dB
	A	B
			2			2	2				2	2		2	2		l0
			3			3	3				3	3		3	3		9		MEMORY		EDIT	TUNING
																							MODE
	ON	OFF	4			4	4				4	4		4	4		8
			5		5		5			5		L 5		5 R	5 6 7
																			MAN’L/AUTO FM			AUTO/MAN’L MONO

2, 1 4, 2 3

To store stations

1 Tune to a desired station.

(Refer to the previous page for tuning procedure.)

2 Select a desired group (A – E) of preset stations confirming it on the display.

A/B/C/D/E

3

MEMORY

MEMO

MAN’L/

Flashes on and off for about 5 seconds.

4 Select a preset station number where you want to program the station before the “MEMO” indicator goes off from the display.

1 2 3 4 5 6 7 8

		Shows the
AUTO		displayed station
MHz		has been
	0 20 l00
		programmed to
		A1.

*In the same way, program other stations to A2, A3 ... A8.

*You can program more stations to preset station numbers of other groups in the same way by selecting other groups in step 2.

To recall a preset station

1 Select the group of preset stations.

A/B/C/D/E

2 Select the preset station number.

1 2 3 4 5 6 7 8

AUTO

MHz 0 20 l00

Notes

•A new setting can be programmed in place of the former one.

•For presets, the setting of the reception mode (stereo or monaural) is stored along with the station frequency.

Memory back-up

The memory back-up circuit prevents the programmed data from being lost even if this unit is turned into the standby mode or the power plug is disconnected from the AC outlet or the power is cut due to temporary power failure. If, however, the power is cut for more than one week, the memory may be erased. If so, it can be re-programmed by simply following the PRESET TUNING steps.

18