Yamaha RX-596 BASIC OPERATIONS, English, TO PLAY A SOURCE

From page 13 to 19, this manual describes how to operate this unit mainly by using the front panel control parts. To operate this unit on the remote control transmitter, use the corresponding keys on the remote control transmitter.

BASIC OPERATIONS

TO PLAY A SOURCE

2																									7
		NATURAL SOUND STEREO RECEIVER RXl596
	STANDBY/ON																						CD	DIRECT				PURE
																		DOWN	TUNING		UP			AMP				DIRECT
						PRESET	AM						STEREO
							FM					MHz
						MEMORY					AUTO TUNING			SLEEP
																	MEMORY		EDIT		FM/AM		INPUT				VOLUME	l6			1, 6
									PRESET STATIONS									MAN’L/AUTO FM							20				l2
			A/B/C/D/E													TUNING MODE							TUNER
				1	2		3	4		5		6		7	8					REC OUT		TAPE 1			CD
			ON	ON	2			2		2			2	2	2	2		l0							60			2
																					TUNER	VCR/			28			8
																		AUTO/MAN’L MONO	TAPE 1		CD	TAPE 2				PHONO
																			VCR/TAPE 2			PHONO			40					4
	PHONES		SPEAKERS				BASS				TREBLE			BALANCE		LOUDNESS			LD/TV			LD/TV
			A	B			l 0	l			l 0	l		l 0	l	l	FLAT –30dB
						3		3		3		3		3	3	3	9											0
			OFF	OFF		4		4		4		4		4	4	4	8											–dB
							5	5		5		5		L 5	5 R	5 6 7

4 7 3

1	VOLUME	l6			4 Select the speakers to be used.
	20		l2
	28		8		SPEAKERS
					A	B
	40			4	ON	ON
					OFF

602

		0
		–dB
Set to the “∞		” position.	* If you use two speaker systems, press both the A and B
			switches.
2 Turn the power on.			5 Play the source. (For detailed information on the
	STANDBY/ON		tuning operation, refer to page 16.)
			6
			VOLUME	l6
			20	l2
3 Select the desired input source by using the INPUT			28	8
selector.			40	4
(For video sources, turn the TV/monitor ON.)			60	2
	INPUT			0
				–dB
	TUNER
TAPE 1		CD	Adjust to the desired output level.
TAPE 2		PHONO
VCR/
LD/TV
			7 If desired, adjust the BASS, TREBLE, BALANCE and
			LOUDNESS controls, etc. (Refer to page 15.)
* The name of the selected input source position will
appear on the display. (For “TUNER”, the tuning mode			When you finish using this unit
will appear on the display.)
			Press the STANDBY/ON switch on the front panel again or
* Note that selecting each input source position selects the
			the POWER OFF key on the remote control transmitter to turn
source which is connected to the corresponding input
			this unit into the standby mode.
terminals on the rear panel.

English

13