ADJUSTING THE SPEAKER BALANCE

This procedure lets you adjust the sound output level balance between the main, center and rear speakers by using the built-in test tone generator. When this adjustment is performed, the sound output level heard at the listening position will be the same from each speaker. This is important for the best performance of the digital sound field processor, the Dolby Pro Logic decoder and Dolby Digital decoder.

Before You Start Adjusting

2

1

 

 

 

 

 

–

+

–

+

3 4

1 Set VOLUME to the “ m” position.

2 Turn the power on.

3 Press SPEAKERS A or B to select the main speakers to be used.

If you use two main speaker systems, press both A and B.

4Set BASS, TREBLE and BALANCE to the “0” position.

–

+

–

+

L

R

Using the Test Tone

The adjustment of each speaker sound output level should be performed at your listening position with the remote control. After completing the adjustments, use VOLUME (/) at your listening position to check if the adjustments are satisfactory.

4 5

1,6

2

PREPARATION

 

 

 

1Press TEST.

“TEST LEFT” appears on the display.

2Turn up the volume.

You will hear a test tone (like pink noise) from each speaker for about two seconds in following order: left main speaker, center speaker, right main speaker, right rear speaker and left rear speaker. The display changes as shown below.

TEST TEST

LEFT RIGHT

TEST CENTER

TEST L SUR.

TEST R SUR.

Notes

•If the test tone cannot be heard, turn down the volume, set the unit in the standby mode and check the speaker connections.

•If the test tone cannot be heard from the center speaker, check the setting of “CENTER SP” in the SET MENU.

English

17