DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT
Selecting a DSP Program
You can enhance your listening experience by selecting a DSP program. Refer to pages 23 to 25 for details about each program.
– | + | – | + |
2
2
1Make sure that the effect speakers (center, rear, and subwoofer) are turned on.
2Press PROGRAM h or l (or DSP PRG+ or
PRG– ) repeatedly to select the desired program.
The name of the selected program appears for a moment and the selected DSP program indicator lights up on the display.
or
y
If desired, adjust the delay time and the sound output level of each speaker. (Refer to pages 38 and 39 for details.)
Notes
•You can select a DSP program for each of the input sources. Once you select a program, it is linked with the input source selected at that time. So, when you select the input source next time, the same program is automatically selected.
•When a monaural source is being played with PRO LOGIC/ Normal or PRO LOGIC/ENHANCED, no sound will be heard from the main speakers and the rear speakers. Sound can only be heard from the center speaker. However, if “CENTER SP” in the SET MENU is set to the NONE position, the center channel sound is output from the main speakers.
•When a source connected to the EXTERNAL DECODER INPUT terminals of this unit is selected, the digital sound field processor cannot be used.
Canceling the Sound Effect (turning
off the effect speakers)
Press EFFECT to cancel |
|
the sound effect and |
|
monitor only the main | Front panel |
sound. | or |
| |
Press EFFECT again to turn the |
|
sound effect back on. |
|
| Remote control |
Notes
•If the sound effect is canceled when Dolby Digital is decoding, the sounds of all channels are mixed and output from the main speakers.
•If you turn off the sound effect when Dolby Digital is decoding, it may happen that the sound is output faintly or not output normally, depending on the source. In that case, turn back on the sound effect.
Front panel | Remote control | |
|
|
|
|
|
|
|
|
|
|
|
|
DSP program indicator
22