CONNECTIONS
Connecting Speakers
Be sure to connect the right channel (R), left channel (L), “+” (red) and
CAUTION
•Use speakers with the specified impedance shown on the rear panel of this unit.
•Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage the unit and/or speakers.
■Speaker cables
|
|
|
|
|
|
|
|
| 1 Remove approx. 10 mm (3/8”) of insulation |
|
|
|
|
|
|
|
|
| |
10 mm (3/8”) |
|
|
|
|
|
|
| from each of the speaker cables. | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 2 Twist the exposed wires of the cable together |
1 |
|
| 2 |
|
|
| |||
|
|
|
|
| to prevent short circuits. | ||||
|
|
|
|
|
|
|
|
|
|
■Connecting to the MAIN SPEAKERS terminals
Red: positive (+) | 2 |
Black: negative | 1 |
|
3
Banana plug
1 Unscrew the knob.
2 Insert one bare wire into the hole in the side of each terminal.
3 Tighten the knob to secure the wire.
y
(U.S.A., Canada, Australia, China and General models only)
•Banana plug connections are also possible. First, tighten the knob and then insert the banana plug connector into the end of the corresponding terminal.
■Connecting to the REAR and CENTER SPEAKERS terminals
Red: positive (+)
Black: negative
31
2
1 Open the tab.
2 Insert one bare wire into the hole of each terminal.
3 Return the tab to secure the wire.
y
(U.S.A., Canada, Australia, China and General models only)
•Banana plug connections are also possible. First, open the tab and then insert the banana plug connector into the end of the corresponding terminal.
■Main speaker terminals
One or two speaker systems can be connected to these terminals. If you use only one speaker system, connect it to either of the SPEAKERS A or B terminals.
■Rear speaker terminals
A rear speaker system can be connected to these terminals.
■Center speaker terminals
A center speaker can be connected to these terminals.
16